WINGSTUFF GW2018BP User manual

PART NO. GW2018BP / GW2018BPBKBELLY PAN FOR 2018+ GOLD WING (6-SPEED MANUAL & DCT MODELS)
WingStuff.com | Phone: [phone] | Email: [e-mail]
For customer service & technical support please contact:
INSTALLATION INSTRUCTIONS
REQUIRED TOOLS:
1/2” Combination Wrench
Socket Wrench (13mm & 12mm sockets)
BELLY PAN INSTALLATION
QTY.LIST OF INCLUDED PARTS
1
2
2
1
1
1
2
5/16” Square Neck Carriage Bolts
Serrated nylon nuts
Rear T-Bolt M8-20 mm
Steel Hex Jam Flat Nut 12mm + washer
M8-1.25 Serrated Flange Nut + washer
Mounting Brackets (left & right)
Belly Pan for 2018+ Gold Wing
3. OPTIONAL: You can either keep the front
of the belly pan tucked inside or outside of
the front lower cowl.
1. Insert the provided Rear T-Bolt through the
existing oval hole in the center stand base of
the motorcyle
2. Rotate T-Bolt inside the hole at a 90 degree
angle and tighten the thin flat nut to hold the
T-Bolt in place
4. Now you can install the rear of the plate
using the second M8 - 1.15 Serrated Flange
Nut as shown
*Included left and right mounting brackets.
Consider the left and right as your left and
right side in your riding position
5. Remove front right engine guard screw, insert the right bracket as shown, tighten halfway.
Attach the other end to the the pan using the 5/16” Square Neck Carriage Bolts and Serrated
Nylon Lock Nut. Slight twisting of bracket may be required on the right side.

WingStuff.com | Phone: [phone] | Email: [e-mail]
For customer service & technical support please contact:
7. Now that the belly pan is attached at all three mounting points, go back and tighten the crash guard bolts and belly pan bolts. Re-install left side
engine cover if you removed it.
Tip: For oil change there is no need to remove the top engine guard bolts. Only the 3 screws that are attached to the bottom of the belly pan
6. OPTIONAL: You can either remove the left side engine cover, or leave attached. If you do not remove it, the combination wrench is the best
way to remove engine guard bolt. Repeat same steps as you did with the right side bracket