Winters WinSMART TY52 Series Manual

Elbow
with
WinSMARTTM TY52 SeriesTemperature Transmitter
Installation and Maintenance Manual
WINTERS INSTRUMENTS Tel: 1-800-WINTERS / www.winters.com
Safety Precautions:
Temperature sensor/transmitter shall be installed by
please read carefully the content and important information provided
by this installation guide before installation
Temperature sensor/ transmitter is powered by an external
power supply, the power supply should be in accordance with
local standards
Disassemble the instrument under the condition of
normal atmospheric pressure only
Label
The gaskets of tri-clamp and all the wetted parts comform with FDA standards
Product Usage
Process Connection
direction, wall thickness and outer shape of protection tube, insertion
depth, as well as pipe material, heat insulation material of container
should be considered when installing the temperature sensor/ transmitter
Protection tube should contact media.
The insertion depth should be half of
the pipe diameter (at least)
(at
)
layer.
wrench
Hollow
Choose gaskets with material of
PTFE, silicon rubber and FKM which
conform to hygienic standards
Choose gaskets according to
a
out
The axis of the protection tube and virtical

WinSMARTTM TY52 SeriesTemperature Transmitter
Installation and Maintenance Manual
Tel: 1-800-WINTERS / www.winters.com WINTERS INSTRUMENTS
Signal Connection
Electrical Connection
utilized as
Power Supply
wiring for
Grounding
E
Cable Protection System
Maintenance
External Cleaning
Transportation / Storage
(-40~212°F)
Metal housing and ground screw terminals are used for grounding
the cable and into the junction box
or transmitter housing, a U-shaped installation
box and temperature transmitter (as
picture shows), ensure the U-shaped
bottom is under the temperature
transmitter. Enough cable length
needs to be considered for manufacturing or
transmitter in dangerous situations, use
connect the signal cable into junction
box and beyond to the safe zone
the instrument
gaskets.
outside
corrosive medium
2) to2) to
2) to2) to
1);1);
1);1); replacement
tubing
the

WinSMARTTM TY52 SeriesTemperature Transmitter
Installation and Maintenance Manual
WINTERS INSTRUMENTS Tel: 1-800-WINTERS / www.winters.com
EMC Statement
local
Ensure proper packaging to avoid damage
durin
g
trans
p
ortation
Keep the temperature transmitter away from any
dangerious media
Retransport
Trouble Shooting
Repair
Discard / Disposal
03/19
conforms to all the
Complete the following steps before sending the unit for repair.
Do not return the instrument if you cannot ensure the
The instrument does not comply with WEEE 2002/96/EG
When device malfunction is suspected despite the absence of any diagnostic
messages, inspect the following:
• If measurement signal appears irregular, check whether the process temperature
is within the working range, or the abnormality lies in the measuring
system, installation environment or temperature transmitte r. Once diagnosed
take corresponding measures
• If no signal output or unchanged output signal on corresponding process
temperature changes is observed, then check the power supply polarity
, open or
short circuit. Check the parameters like voltage, power and load resistance mee t
ro egakael on si ereht erusne ,oslA .stnemeriuqer gnikrowlamron eht
line blockage
• If the output signal is large or outside the normal range, check whether the
supply voltage, power consumption, and load resistance meet the normal
sgnittes egnar gnirusaem
yfireV .rettimsnart erutarepet fo stnemeriuqer gnikrow m
,egakael on si ereht erusne ,oslA .noitarbilac ecived eht tsujda dna
line blockage
as
eht
or