WIPCOOL P18 User manual

OPERATION MANUAL
feeling for more
Silence Running,
Reliable And Durable
P18/P36
CONDENSATE PUMP

feeling for more
02
7
170
80
88
25
6
85
POWER
IN
OUT
Storage tank
Circuit board
Alarm buzzer Level Power socket
Water inlet
Water outlet
2. Dimension
1. Product indication chart
Motor
feeling for more
P18
100V-230V~/50-60Hz
10m
36L/h(9.6GPH)
150ml
0℃~50℃
45000btu/hr
21dB(A)
P36
12
10
8
7
6
2
0 5 10 15 20 25 30 35 40
P36
P18
4. Flow Rate Chart
P16
P36
0m
24
40
2m
20
36
4m
18
26
6m
16
22
8m
12
18
10m
8
14
3. Technical Data
Model
Voltage
Discharge head(Max.)
Flow rate(Max.)
Tank capacity
Mini splits up to
Sound level at 1m
Ambient temp.
Model
Performance(l/h@head)
Meters head（m）
Flow（L/h）
19dB(A)
18L/h(4.8GPH)
30000btu/hr
01

03 04
feeling for morefeeling for more
2. Do not place electrical appliances or valuables under the condensate pump
to avoid loss caused by power failure or water leakage.
3. Non - professional personnel should not install it to avoid danger.
4. The condensate pump is not waterproof. Do not place it in the open air,
outdoors or in a place prone to flooding.
5. The condensate pump power supply needs to be independent to maintain
permanent power supply. For details of connecting with air conditioning
system, please refer to the wiring diagram.
6. It is prohibited that the water inflow is bigger than our stated flow rate, which
will easily cause the motor to work continuously and fail. Instant big water
inflow will also cause the condensate pump fail to discharge water in time,
leading to water leakage.
7. The condensate pump has a built-in buzzer. When the buzzer sounds all the
time, please turn off the air conditioner and ask a professional to repair it.
5. Safety Instructions
1. Place the tank horizontal when installing, do not tilt the pump. Check whether
the level drop is centered; if there is tilt, adjust the water level before using it.
6. Installation Procedure
6.1 Cut off the power;
6.2 Install the hanging plate ( in the accessory bag ) horizontally at a suitable position,
and then hang up the condensate pump;(As shown below)
Fix with 4x20 screws
Power supply
6.3 Put the pipe of the system into the water inlet of pump, and connect the pipe with
6x9 plastic pipe and fix it with tie ( tie is in the accessory bag );(As shown below)
Inlet pipe
Outlet pipe
Fix with tie
Horizontal installation of spirit level center
Fix pump into
plate groove

05 06
feeling for more
Pump runs
all the time
1. Installation is not horizontal
2. There is sludge inside tank
Problem Cause Action
Pump makes
loud noise
Pump can’t
start working
Adjust the tank make it level
Clean the inside of tank and probe surface
1. The water is siphoning back
in the pump
Check whether the outlet pipe is lower than
pump thus result in siphoning, please raise the
condensate pump position
1. Installation is not horizontal
2. The power can’t reach pump
3. The voltage isn’t correct
1. Adjust the tank, check water level
2. Check power supply
3. Check the voltage
7. Troubleshooting
6.4 Connect power supply;
6.5 After the system is properly connected, ensure that the pump is powered on,
run the air conditioner and observe whether the pump is working normally. If
the pump does not work properly, please contact a professional for repair.
(As shown below)
feeling for more
6.6 The condensate pump is built in working indicator lamp, and the green light
on the front cover is on when working, and the alarm buzzer will emit a
" drip .... drip" sound when the pump fails to drain water.
Work indicator
Note: Proper use and maintenance can improve the life of pump. We suggest to
check and clean the condensate pump before seasons changing or next year using.