Wisenet PRO-7310B6 User manual

PRO-7310B6
PRO-7510B4
PC NVR for Recording
Quick Guide

Copyright
©2022 Hanwha Techwin Co., Ltd. All rights reserved.
Trademark
Each of trademarks herein is registered. The name of this product and other trademarks mentioned in this manual are the registered
trademark of their respective company.
Restriction
Copyright of this document is reserved. Under no circumstances, this document shall be reproduced, distributed or changed, partially or
wholly, without formal authorization.
Disclaimer
Hanwha Techwin makes the best to verify the integrity and correctness of the contents in this document, but no formal guarantee
shall be provided. Use of this document and the subsequent results shall be entirely on the user’s own responsibility.
Hanwha Techwin reserves the right to change the contents of this document without prior notice.
Design and specications are subject to change without prior notice.
PC NVR for Recording
Quick Guide

3
●TABLE OF CONTENTS
Table of Contents
OVERVIEW
4
4Before reading the user manual
6Conguration and Tips of User Manual
7Package Contents of PRO-7310B6
8Package Contents of PRO-7510B4
9Part Names and Functions
HDD INSTALLATION
11
11 How to Install HDD
12 How to Attach HDD
EXECUTION
15
15 Power Supply
16 How to create a logical drive
17 How to congure advanced logical drives
24 Network settings
25 How to create network teaming
30 How to Launch SSM
31 Menu Description

4_ Overview
Overview
Before reading the user manual
Be sure to read the following before reading the user manual.
• This manual is copyrighted by the manufacturer.
• This manual cannot be reproduced without permission.
• We are not responsible for any damage caused by using products other than the standard product or using the
product for the purpose other than mentioned in the manual.
• If you need to open the case and touch the inside of the case for troubleshooting, always contact the dealer where
you purchased the product for professional help.
• Do not allow water or liquid to come into contact with the connections of the product.
• Do not apply excessive force or shock.
• Do not pull the power cord by force.
• Do not disassemble the product.
• Use only within the rated input/output power range.
• Use only approved power cords.
• For products with an input ground, be sure to use it with a grounded power plug.
• If a wrong battery is used, there is a risk of an explosion. Never replace the batteries with ones that aren’t the same
model or equivalent product.
• Be cautious so that the batteries are not exposed to excessive heat, such as sunlight or fire.
• Place the power plug where it can be easily operated. If there is a problem with the product, you should unplug the
power plug to completely terminate the power. The power will not be completely terminated by only turning off
the main body’s power button.

5
●OVERVIEW
PUSH
REC
1234
5678
910 11 12
ALARM POWER
NETWORKRAID
USB
HDD
PUSH
1234
5678
910 1112
USB
PUSH
HDD
1234
5678
910 11 12
USB
HDD
PUSH
PUSH
Checking the Installation Environment
This product is a state-of-the-art security equipment with a high capacity hard disk and important circuitry
inside.
When the temperature inside the product is too high, its life cycle might be shortened, or it might be broken.
Therefore, install it so that it is well-ventilated, and refer to the following recommendations before installation.
When installing this product in a rack, observe the following recommendations.
1. Make sure that the inside of the rack where the product is installed is not
sealed.
2. As shown in the gure, make air circulation smooth through the intake and
exhaust ports.
3. If you are stacking the product together with other rack-mounted products as
shown in the gure, secure a certain amount of space or install a vent for air
circulation.
4. For natural convection of air, install the intake port at the bottom of the rack
and the exhaust port at the top.
5. It is highly recommended to install a fan motor for air circulation in each intake
and exhaust port. (Install a lter that lters dust or foreign matter in the intake
fan.)
6. Keep the temperature inside the rack or around the product between 5 °C and
40 °C as shown.

6_ Overview
Overview
The manual of this product is composed as follows.
yQuick Guide
ySSM User Manual
ySystem User Manual
This User Manual is the default setting for user's guide. The User Manual contains the following in order:
If you want to apply the modification to the actual operating environment, refer to the SSM User Manual and the
System User Manual.
yChecking components
yProduct name and functions
yHow to install a hard disk
yHow to create a logical drive
yHow to set up a network
yGuide to SSM operation and installation start
J
`The operating system and application software installed on this product are optimized for the hardware of this
equipment.
Do not add or remove any hardware, or update the operating system, or install any other software.
Or it may cause the risk of electric shock and product performance degradation.
Configuration and Tips of User Manual

7
●OVERVIEW
Package Contents of PRO-7310B6
NVR Mouse Power cord
Quick Guide HDD mounting screws Hard disk tray label
M
`Accessories other than the NVR body are consumables and are excluded from the warranty.
`All manuals can be downloaded from our homepage (www.hanwha-security.com).
`Rack mounting brackets for mounting in the server rack are sold separately.

8_ Overview
Overview
Package Contents of PRO-7510B4
NVR Mouse Power cord
DISC 1 DISC 16
Quick Guide HDD mounting screws Hard disk tray label
M
`Accessories other than the NVR body are consumables and are excluded from the warranty.
`All manuals can be downloaded from our homepage (www.hanwha-security.com).
`Rack mounting brackets for mounting in the server rack are sold separately.

9
●OVERVIEW
Part Names and Functions
Front (PRO-7310B6)
a
b
d
c
Front (PRO-7510B4)
a
b
d
c
No Name
a
Power button
b
USB Port
c
Hard disk tray
d
Power and status LEDs

10_ Overview
Overview
Rear
a b k
<IO Ports>
c d e f g h
i
j
No Name No Name
a
Power input
g
USB 3.0 (4 ports)
b
System fan
h
Optical SPDIF output port
c
PS/2 Mouse/Keyboard port
i
Audio IO port
d
VGA port
j
1000BASE-T RJ-45 (Internal 2 ports)
e
DVI port
k
1000BASE-T RJ-45 (External 4 ports)
f
HDMI port