CONVECTION MICROWAVE CONTENTS
1 Assembly, frame
4 Stud, ball
4 Insert, threaded
3 Assembly, duct (bottom, rear, and top)
1 Template
12 Screw
STANDARD MICROWAVE CONTENTS
1 Assembly, frame
4 Stud, ball
4 Insert, threaded
1 Assembly, duct (bottom)
1 Template
2 Screw
M SERIES MICROWAVE TRIM INSTALLATION
1For a standard microwave proceed to step 7.
2Insert the horizontal duct into the vertical duct to create
the rear duct assembly and secure with one screw.
3Remove the existing screws from the upper right and
left rear of the microwave.
4Position the rear duct assembly on the microwave and
install the screws.
5Position the three remaining duct sections on top of the
microwave to create the top duct assembly.
6Secure each section with two screws (one per side) and
insert one screw in the top section.
7Install the bottom duct assembly. The duct must be
recessed from the front edge of the opening. Refer to
the chart below. NOTE: For black trim only, the center
of the duct must also be offset 3/8" to the right of the
centerline of the opening.
Microwave Recess Depth
Convection 3/4"
Standard 1/8"
M Series Microwave Trim Installation
www.subzero-wolf.com 800.222.7820
9018827 REV-B TINSKB244MRR2 10/2018 Page 1 of 2 *9018827$REVB$$$$
$TINSKB244MRR2*
