wonderwall Medium Kit User manual

Living walls made easy
Instruction Manual
Create the ultimate
hassle free living wall
14 x wonderwall planters,
6 x wooden battens, 12 x rawl plugs,
4 x water plugs,12 x batten screws,
18 x planter screws
Kit includes:
1 sqm kit

2
Contents
Box Contents
1. Planter set x 14
2. Wooden batten x 6
3. Batten rawl plug x 12
4. Batten screw x 12
5. Planter screw x 18
6. Water plug x 4
Required tools and auxiliary materials
A. Tape measure
B. Drill and 8mm drill bit
C. Screwdriver
D. Spirit level
E. Watering can/hose
F. 11-13cm potted plants x 42

3
General Information
General Information
This chapter contains general information about the product
and the manual.
Reading and storing the user manual
This user manual belongs to this vertical 1m² kit (referred to as the
“product” below). It contains important information on how to
set up and use the product.
Read the user manual carefully, the safety instructions, before
using the product. Failure to follow this user manual may lead
to severe injuries or product damage.
This user manual is based on the standards and regulations that
are valid within the European Union. Outside the EU, please also
note the country-specific directives and laws.
Keep this user manual for future reference. If you pass this product
on to a third party, you must also supply this user manual.
Intended use
The product is exclusively designed to create a vertical living wall
at home. It is for private use only and not for commercial use.
Only use the product as described in this user manual.Any other
use is improper and may lead to product damage not covered
by the warranty or even personal injury.
This product is not a toy.
The manufacturer or retailer assume no liability for damage
caused by improper or incorrect use.

4
Safety notes
This product can be used by children aged 8 years and
above, and by persons with reduced physical, sensory, mental
capabilities or lack of knowledge if they are supervised by
a competent person, and they understand all potential hazards.
Before you begin your install read this guide and check the
vertical surface is stable. Only use the product for its intended
use. For installs above the height of 2m+, consider the influence
of wind. Never modify or cut the planter set.
When using a power/cordless drill you must:
• Avoid loose clothing, jewellery and hair can be a hazard
when you are operating a drill.
• Wear protective safety goggles, breathing mask if the
material you’re drilling produces a lot of dust or shavings
and form-fitted gloves.
• Secure the wooden batten with a clamp or vice before
applying the drill to it.
• Drill pilot holes to make it easier to insert a screw and this
reduces slippage.
• Make sure the 8mm drill bit is properly inserted into the chuck
and tighten it firmly with the chuck key.
• Apply proper pressure to the drill, it should do most of the
work. If pushed too hard, the drill can slip or strain the motor.
General Information

5
Installation Diagram
Battens
35cm
apart
7cm
2A
2C 2D
1A
1C
2E
1E
2F
1F
1D
6
F
2B
1B
3A 3A 3B
3C 3D
3E 3F3E
3C
3B
3F
3D
E
Battens
35cm
apart

6
Installation Instructions
Instructions provided below relate to the diagram on page 5.
This vertical planter kit is modular and can be installed in many
formations.
1. Check the vertical surface is sturdy.
Attach bottom battens 2A & 2B:
1. Measure and mark up surface location for bottom
battens 2A & 2B.
2. Drill screw holes through battens 2A & 2B using a drill and
8mm drill bit.
3. Mark up rawl plug locations 3A & 3B, drill a hole to depth
of approx. 4cm and insert rawl plugs.
4. Using a spirit level, attach bottom battens 2A & 2B using
a screwdriver and batten screws x4.
Attach bottom planter sets 1A & 1B:
1. Attach bottom planter sets 1A & 1B to bottom battens
2A & 2B using planter screws x6.
2. Stack six planter sets on top of each other (in 3 rows of 2).
Attach middle battens 2C & 2D:
1. Using middle planter sets 1C & 1D mark location for
middle battens 2C & 2D. This should be 35cm above
bottom battens 2A & 2B and offset 7cm to the left.
2. Remove middle planter sets 1C & 1D then drill screw holes
through battens 2C & 2D using a drill and 8mm drill bit.
3. Mark up rawl plug locations 3C & 3D, drill holes to depth
of approx. 4cm and insert rawl plugs.
4. Using a spirit level, attach middle battens 2C & 2D using
a screwdriver and batten screws x4.

7
Installation Instructions
Attach middle planter sets 1C & 1D:
1. Attach middle planter sets 1C & 1D to middle battens
2C & 2D using planter screws x6.
2. Stack six planter sets on top of each other (in 3 rows of 2).
Attach top battens 2E & 2F:
1. Using top planter sets 1E & 1F mark location for top
battens 2E & 2F. This should be 35cm above middle
battens 2C & 2D and offset 7cm to the right.
2. Remove top planter sets 1E & 1F then drill screw holes
through battens 2E & 2F using a drill and 8mm drill bit.
3. Mark up rawl plug locations 3E & 3F, drill holes to depth
of approx. 4cm and insert rawl plugs.
4. Using a spirit level, attach top battens 2E & 2F using
a screwdriver and batten screws x4.
Attach top planters 1E & 1F:
1. Attach top planter sets 1E & 1F to top battens 2E & 2F
using planter screws x6.
If required, insert water plugs 6 as indicated.
Irrigation Eand plants F:
1. Using a hose pipe/watering can E, water the planter sets
from the top planter sets 1E & 1F till they are full.
2. Insert 11-13cm diameter/l0cm (H)/1 litre potted plants,
edibles or herbs x42 Fof your choice into each pocket.

8
Maintenance and Disposal Notes
Faults and Troubleshooting
How to insert potted plants
Never plant directly into a planter set. Use 11-13cm diameter
x l0cm(H) or 1L potted plants. This will avoid blocking the inbuilt
water filters. If a water filter is blocked, plants will perish.
How to care for plants during winter
To protect plants that are susceptible to frost (less hardy), we
recommend covering plants with a ‘garden fleece’. Using a
garden fleece can help provide protection in several ways: frost,
wind, and adverse weather conditions such as hail, rain, heavy
winds etc. A garden fleece raises temperatures and humidity
under the cover, and provides protection from birds and insects.
Cleaning and maintenance
Clean every six months to avoid blockages.
1. Remove plants, remove debris (leaves/soil) from each
planter set by hand.
2. Wipe planter sets with a damp cloth (water).
3. Flush the system using a watering can or hose.
4. Replace plants.

9
Technical data
Indoor/outdoor durable self-irrigating vertical planter system
made from recycled propene polymer (PP).
Planter set dimensions: 480mm(L) x 180mm(H) x 160mm(D).
Each planter has three potted plant pockets and two built-in
water filters.
This kit covers surface area: 1m² in various formations or split into
smaller living wall projects.
Each planted planter set weighs approx. 4kg
(weight includes planter set, plants, soil and water).
Disposal notes
Planter sets are recyclable. Use home recycling collection bin.
Wooden battens are recyclable. Take it to a local household
waste recycling centre.
Screws and rawl plugs are not recyclable. Use normal home
waste collection bin.
Maintenance and Disposal Notes

10
Warranty Conditions
Dear Customer,
The Wonderwall warranty offers you extensive benefits:
Warranty period: 1 year from date of purchase.
Costs: Free repair/exchange
No transport costs
Hotline: [phone]
Phone lines available: Monday-Friday 09:00 AM - 06:00 PM
Closed Bank Holidays
In order to make a claim under the warranty, please send us:
• The faulty item together with the original purchase receipt and the
completed warranty card
• The product with all components included in the packaging
The warranty does not cover damage caused by:
• Accident or unanticipated events (e.g. lightning, water, fire)
• Improper use or transport
• Disregard of the safety and maintenance instructions
•Other improper treatment or modification of the product
After the expiry of the warranty period, you still have the possibility to have your
product repaired at your own expense. If the repair or the estimate of costs is
not free of charge you will be informed accordingly in advance.
This warranty does not affect your statutory rights. In the event that a product is
received for repair, neither the service company nor the seller will assume any
liability for data or settings possibly stored on the product by the customer.
Please contact our after sales support by phone or e-mail before sending in the
device.This allows us to provide support in the event of possible operator errors.

11
Warranty Card
Warranty Card
Vertical Planter
1 sqm Kit
Please contact our after sales support by phone or email before sending in the
device. This allows us to provide support in the event of possible operator errors.
After sales support
Tel: [phone]
Email: [email protected]
Model:
Wonderwall Medium Kit
Description of malfunction:
Your details: Date and location of purchase:
Name:
Address:
Email: Tel:
Product code USP-VP-KI-1M2-1
Service centre
c/o Midon Ltd
Unit 2C Penrhyn Court
Penrhyn Road
Knowsley Business Park
Prescot, L34 9AB, UK
03/2022

Great care has gone into the manufacture of this product and it
should therefore provide you with years of good service when used
properly. In the event of product failure within its intended use over
the course of the first year after date of purchase, we will remedy
the problem as quickly as possible once it has been brought to
our attention. In the unlikely event of such an occurrence, or if you
require any information about the product, please contact us via our
helpline support services, details of which are to be found both in this
manual and on the product itself.
USP Creations Ltd: Unit C2, Penrhyn
Court, Penrhyn Road Knowsley
Business Park
Prescot, L34 9AB, UK
www.wonderwall-promo.co.uk
This kit can be used by persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and
understand the hazards involved.
After sales support
Tel: [phone]
Email: [email protected]
Model:
Wonderwall Medium Kit 03/2022
720740
Year
Warranty