Woodbridge MBSDC4876 User manual

WOODBRIDGE

20200307 REV. 3

www.woodbridgebath.com 1

IMPORTANT!

Questions?

SHOWER DOORS:

MBSDC4876

MBSDC6076

TUB DOORS:

MBTDC6062

WOODBRIDGE reserves the right to alter, modify or redesign products at any time without prior

notice for the purpose of product improvement and customer experience. Please refer to

WWW.WOODBRIDGEBATH.COM for the latest product details.

Please Call Customer Support: 562-229-0088. (Monday - Friday 9 AM - 5 PM Pacific Time)

Or Email: [email protected]

SHOWER DOOR

INSTALLATION MANUAL

WOODBRIDGE

www.woodbridgebath.com 2

IMPORTANT

•WoodBridge reserves the right to alter, modify, or redesign products at any time

without prior notice for product improvement or functionality.

•Professional installation required. This product should be installed by someone

experienced with the construction requirements for this type of project, the care

necessary to responsibly and safely install, and familiarity with glass installation.

•The safety of all installations is the responsibility of the installer who should be

licensed and bonded.

•To prevent breakage and injury, do not attempt to lift, move, or install the glass

alone. Use an assist and suction cups intended for heavy glass when applicable.

•To prevent breakage and injury, do not lean or push against glass panels.

•The installation of this model requires drilling into the dam/curb/threshold to

properly affix the clip, guide, and threshold. Contact the manufacturer of your

base, or tub with any questions regarding drilling into their product, or consult your

installation professional.

•This model requires minimum 3" dam/curb/threshold width to complete

installation.

•Drawings included in this manual are illustrative only and do not reflect actual

scale.

•No out of plumb adjustment.

•Glass cannot be installed if the overall width of the shower opening is greater than

the width as described for the product.

WARNING FOR TEMPERED GLASS: TO AVOID RISK OF DAMAGE OR INJURY

•Tempered safety glass is designed that when broken, will shatter into thousands of

tiny pieces, greatly reducing the chance of great bodily harm.

•Follow all requirements and recommendations in the instruction manual.

•Perform a thorough inspection of the glass and hardware for any damage prior to

installation.

•Do not install damaged glass.

•Do not install or operate if glass panels have chipped corners, slivered edges, or

any other visual defect. If damage is found contact WoodBridge immediately. If

installed in this state WoodBridge is not responsible for any breakage.

•Do not install glass panels that have been dropped on, or bumped into any

surface harder than itself.

•Improper handling may cause breakage.

While incredibly resistant to direct impact, corners and edges are the most

susceptible to damage, causing breakage. These edges should be protected and

handled with care, never allowed to come into contact with any material harder

than itself, such as tile, stone, metal, or even other glass. A concentrated point of

impact or contact with such material can cause the glass to shatter. Tempered

glass may release all at once, or partially, releasing hours or even days later with

vibration and normal use.

•Incorrect installation of the hardware, rollers, stoppers, or glass may cause

breakage.

Improper installation would include loose hardware, or lack of gaskets between

hardware and glass. Installing out of level or plumb causing extra stress could

WOODBRIDGE

www.woodbridgebath.com 3

•Improper use of the product.

Do not place towels or anything else over guide rail. Aggressively opening or

closing the slider may cause trauma to the glass which could lead to breakage.

•Do not attempt to cut tempered glass.

•Always wear safety equipment such as goggles, work gloves, proper footwear

etc... during installation.

•Instruct homeowner on how to conduct periodic inspections and how to

properly maintain the glass and all hardware.

•Consideration should be given when installing tempered glass products in

households with young children or elderly.

PREPARATION

•Thoroughly read the instructions before installing or using the product.

•After boxes and packages are open, before installation, check that all items

from the parts list are there by marking each one off the list.

•Examine the glass and parts for defects or damage.

•Please note that Woodbridge will not replace any missing or damaged items

free of charge after 5 business days or if the product has been installed.

•Building codes vary by location and you should refer to your local building

codes when installing. WoodBridge is not responsible for code compliance and

will not accept returns on that basis.

•Prior to installation ensure that all surfaces are smooth and even. Ensure the

dam/curb/threshold is level side to side and that it has slope/fall in the direction

of the shower pan. Ensure the walls are plumb and the opening measures the

same top and bottom. Ensure that the installation surface is solid and able to

support the weight of the doors.

•Please note that irregular installation surface, round lower corners, or out of

plumb walls will result in serious problems for your installation.

•Some adjustments and drilling/screwing will be necessary throughout

installation.

•Woodbridge shower doors are not designed to be installed on fiber glass

surrounds that have round lower corners or lack of solid mounting surface.

•Glass must never be set down directly on any hard surface. Always use pieces

of wood or thick cardboard to protect lower edge at all times. Leave corner

protectors in place until it is time to remove them

WOODBRIDGE

www.woodbridgebath.com

WOODBRIDGE

IMPORTANT INFORMATION

REGARDING THE INSTALLATION

OF THIS SHOWER DOOR

CBA

A.Guide Rail Brackets must be firmly attached to the wall. Installation into a stud is

strongly recommended. All of the guide rail bracket set screws must be accessible

and tightened.

B.Thread Lock must be applied to the set screws in both stoppers. Door-side stopper

must be installed at the proper position to prevent the door from contacting the wall.

D.The Guide Block must be screwed to the threshold and installed square with the

Stationary Glass and Glass Door. Installing the guide block crooked may damage

the bottom edge of the Glass Door and lead to breakage.

C.Roller Wheel Assembly safety set screws: must be accessible and must be

retightened with Thread Lock during installation.

D.Bulb Vinyl Seal must be installed on the closing edge of the Glass Door from

contacting the wall.

WOODBRIDGE

WOO

WOODBRIDGE

WOO

WOODBRIDGE

WOO

www.woodbridgebath.com

WOODBRIDGE

INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN SERIOUS INJURY OR DEATH

CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT.

THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION!

LICENSEDANDINSUREDPROFESSIONALCONTRACTOR IS REQUIRED TOINSTALL

THISPRODUCTINCLUDINGASSISTANCEOFASECONDPERSONDURINGINSTALLATION

Nomodificationstotheproductareallowed.Modificationsofanytypes to the product will result in serious injuries or may causedeath.

IMPORTANT:Do not install the handle on to the glass door unl the

instrucon tells you to do so. Never lithe glass using the handle. Failure to

do so will result in serious personal injury and could cause damages to the

glass. Professional graded glass sucon cups are highly recommended while

handling extremely heavy glass. This product must be installed on a ﬁnished

threshold and against ﬁnished walls only. This product is intended for

residenal use only.

Tools

SoftHead

Hammer

Professional-grade

Glasssuctioncup

ExtenderDriverBit

#3Phillips

DriverBit

RazorKnife

Silicone

WorkGloves

SafetyGlasses

SoftCloth

orBlanket SoftWood

Shim

Phillips

Screwdriver

Pencil

Tape

Measure

Level Power

Drill

Drill Bit

Ø1/8"

(3mm)

Drill Bit

Ø3/16"

(4mm)

Drill Bit

Ø1/4"

(6mm)

Drill Bit

Ø5/16"

(8mm)

Drill Bit

Ø3/8"

(10mm)

Mitersaw

Hacksaw

Painter'sTape

WOODBRIDGE

www.woodbridgebath.com

WOODBRIDGE

2mm

2.5mm3mm

4mm

5mm

10 11

WOODBRIDGE

www.woodbridgebath.com

WOODBRIDGE

x1 x2

Bumper Strip

1 2

x2 x1

2mm

2.5mm3mm4mm

5mm

Set

17 18

Guide Rail Bracket Glass Door Stopper

Upper Guide Rail Roller Handle

Glass Door Anti-splash Threshold

Side Anti-Water Strip

Screw M4X30

Allen Key

Guide Block Wall Anchor

Bottom Clamp Stationary Glass Screw M5X60

Glass Bracket Safety Pin

Parts List

BRIDGE

WOODBRIDGE

WOO

www.woodbridgebath.com

WOODBRIDGE

Model Specific Preparation

±0.0±0.0

No Out-of-Plumb

Adjustment; Verify

threshold and walls

with a level

Threshold must be

level

PANEL PANEL

DOOR DOOR

3” minimum

threshold

Threshold must be level

NOTE

This model is reversible for right or left-hand door installation. The right-hand door installation is

shown as an example throughout this manual. For the left-hand door installation, simply begin on the

opposite wall and reverse the orientation of the steps shown.

WOODBRIDGE

www.woodbridgebath.com

WOODBRIDGE

Fig 1

90°

Wall

1.Measure the distance between two finished walls. This distance is marked as W.

Please see Fig 1 for details:

WOODBRIDGE

www.woodbridgebath.com

WOODBRIDGE

Fig2

Door End(no holes)

Door End Panel End

Note: The Glass Brackets have been pre-installed to the roller bar.

2. Your Upper Guide Rail (4) has been

precut for your Shower model opening

width: 48" or 60" for shower width. If

W-width of your wall-to-wall opening is

equal to the size of your shower model,

it is unnecessary to cut the Upper

Guide Rail and you can continue to

Step 3. If W-width of your wall-to-wall

opening is less than the size of your

Shower model, you will need to cut the

Upper Guide Rail from the end which is

farther from the Glass brackets (16)

holes.

The length to cut off will be L:

L=Subtract W from the size of your

Shower model.

Please see Fig 2 for details.

FOR EXAMPLE

If your wall opening W=47". Your shower

model is 48".

L=48"-47"=1",

You have to cut 1" off from the rail.

This manual suits for next models

Table of contents

Popular Projection Screen manuals by other brands

Draper

Draper E Series Installation & operating instructions

Elite Screens

Elite Screens Elite Tripod Series user guide

Laarhoven

Laarhoven Companion II General assembly instructions

Renogy

Renogy RMS-LFPS-US manual

Da-Lite

Da-Lite ExecutiveElectrol Instruction book

Samsung

Samsung S*H65* user manual

FONESTAR

FONESTAR PPTR-43100-FA quick start guide

Slide Clear

Slide Clear Varro XL installation instructions

Elite Screens

Elite Screens M85XWS1-SRM manual

OS РХ-090Н user manual

Niko

Niko 10-845 Product information

Speaka Professional

Speaka Professional 2357532 Important information

Sima

Sima XL-72 instruction manual

Jasic

Jasic EVO 2.0 ET-200P Fitting instructions

Elite Screens

Elite Screens Starling 2 Series user guide

InFocus

InFocus SC-WALL GRY-92H Instruction guide

Barco

Barco OverView MVL-615 Brochure & specs

Draper

Draper Envoy Installation & operating instructions