WOODCO Wolff User manual

Wolff
vanity unit
Contents
Once you have everything out of the box, you will have:
- 2 x shelves (top & bottom)
- 2 x angles (one axed to each shelf) please note that
the centre is marked on each angle
- 2 x legs with screw jack feet, protected with shrink
wrap - please note the shrink wrap must be left on the
leg until legs are installed
- 4 x screws for axing angles to shelves
What you need
- pencil
- measuring tape
- level
- drill with #2 square drive
- 4 x suitable wall fixings (e.g. wall plugs for masonry,
adequate timber screws for studs)
- a drill bit suitable to your wall fixings
- a counter-sink bit suitable to your wall fixings
Installation
Your Wol vanity unit must be fixed to appropriate
fixing points in your wall, ie:
- studs - blocks - brick
Recommended installation guide
[email protected]

C
L
1. Choose the location for your Wol vanity unit
2. Measure the width of your vanity unit and mark the
centre line onto the wall
3. Check your floor for level by placing the level along
the floor approximately where the feet will go
4. Measure the height of the leg disc, measure from the
bottom of the leg to the disc - note: loosen the screw
jack feet a little before measuring
Installation steps
Wolff
vanity unit
[email protected]

5. Mark the leg height measurement onto the wall - note:
measure from the highest point of the floor level. This
is where the underside of the lower shelf angle will be
axed.
6. Use your level to mark the fixing line.
7. Find adequate fixing points on your wall and mark
these onto your angle - note: ensure the centre mark on
the angle aligns with the centre line on the wall.
8. Use your appropriate drill bit to drill out the fixing
holes on the angle.
Wolff
vanity unit
[email protected]

9. Use your counter-sink bit to counter-sink the fixing
holes on the angle.
10. Ax the angle to the wall - note: the angle must sit
above the line; remember to align the centre mark of the
angle with the centre line marked on the wall.
11. Gently slide legs through lower shelf - note: discs
must sit on the under side of the shelf. Be careful not to
remove the protective wrap.
Wolff
vanity unit
[email protected]

12. Use #2 square drive to fix shelf onto angle.
13. Level shelf using screw jack feet (clockwise = higher,
anti-clockwise = lower).
14. Measure from top of shelf to top of leg.
Wolff
vanity unit
[email protected]

15. Measure inside the round notch-out on the underside
of the top shelf (approx 10-12mm).
16. Deduct the notch height from the leg height and
mark this height on the wall - note: use your level to
mark the line. This is the line where the underside of the
top shelf angle will sit.
Wolff
vanity unit
[email protected]

17. Mark the fixing points onto the angle and drill out
and countersink holes.
18. Ax the angle to the wall - note: remember to align
the centre mark of the angle to the centre line on the
wall.
19. Gently remove the protective leg covers.
20. Fit the top shelf onto angle and legs.
21. Fix shelf to bracket, using the fixings provided and a
#2 square bit.
Wolff
vanity unit
[email protected]