Woodstock WACDS User manual

Woodstock Small Arbor Display
Assembly Instructions
WACDS
WACDSIns112917
Revised 11/29/17 ©2017
Step 3.
Attach 2 pieces of Wire Cross Bar (E) to the bottom back of the display,
and secure with the 2 Wing Nuts (e) by hand-twisting clockwise as shown.
Attach 4 pieces of Removable Hook (a) to the side of the display as shown.
Finally, hang all the hooks (b, c, d) to the desired location. Use 2 of the
S-hooks (d) to hang the Header Sign (F).
Woodstock Percussion, Inc.
Shokan, NY 12481-5124 USA
800-422-4463 • 800-4-A-CHIME • Fax [phone]
E-mail: [email protected]•www.WoodstockChimes.com
WACDSinstructions112917.indd 1 11/29/2017 3:54:46 PM

Parts List
A. Bottom Side Panel.........2 Pcs. a. Removable Hook .........4 Pcs.
B. Middle Side Panel.........2 Pcs. b. 12" Hook ...................... 6 Pcs.
C. Wire Grid Shelf............. 2 Pcs. c. 6" Hook ........................ 6 Pcs.
D. Top Arbor Panel ............2 Pcs. d. 3" S-Hook ..................24 Pcs.
E. Wire Cross Bar..............2 Pcs. e. Wing Nut......................2 Pcs.
F. Header Sign.....................1 Pc. f. Wing-head Thumb Screw ...2 Pcs.
Step 1.
Connect 2 pieces of Bottom Side
Panel (A) with 2 pieces of Wire Grid
Shelf (C) as shown.
Step 2.
Remove the two Wing-head
Thumb Screws (f) located in
one of the Top Arbor Panel (D)
sections by hand-twisting
counter-clockwise. Set these
screws aside.
Attach 2 pieces of Middle Side
Panel (B) to the pre-assembled
Bottom Side Panel (A), and
then attach 2 pieces Top Ar-
bor Panel (D) to the Middle
Side Panel (B). Secure the 2
pieces of Top Arbor Panel (D)
with the 2 Wing-head Thumb
Screws (f) by hand-
twisting clockwise as shown.
f
WACDSinstructions112917.indd 2 11/29/2017 3:54:47 PM