World Tech Toys The Outlaw 35984 User manual

PREPARING THE TRANSMITTER
PREPARATION FOR BATTERY CHARGING
PREPARING THE R/C TRUCK
AGES 8+
ITEM NO. 35984
CONTENTS:
1 x The Outlaw RC Monster Truck
1 x RC Transmitter
1 x Instruction Manual
BATTERY REQUIREMENT:
Vehicle: 1 x 12V Rechargeable Battery Pack (INCLUDED)
Transmitter: 1 x 9V Battery (INCLUDED)
1 x 9V Battery
1 x 12V Rechargeable Battery Pack
1 x Wall Charger
Power Switch is at the
bottom of of RC
Place 1x 12V Rechargeable
Battery Pack and connect
to RC battery connector.
TURNING ON / OFF
• This charger can only be used for the battery pack included.
• Do not charge the battery pack for longer than 6 hours. Overcharging
generates excessive heat and will damage the battery pack.
• Use the charger with adult supervision. Do not use the charger near
water or when wet.
• Do not use the charger if the wires are frayed or worn. If the wires
are frayed or worn, a short circuit can cause a fire or

WARNING:
PROBLEM
TROUBLE SHOOTING
CAUSE CORRECTION
1. Do not disassemble the RC vehicle or transmitter.
2. Do not operate the vehicle with the same frequency with other RCs in the same location.
The same frequency RC will cause interference and you will lose control of the vehicle.
3. Make sure the batteries are installed with the correct polarity (+/-) as shown inside the battery
compartment.
Website: www.worldtechtoys.com
Email: [email protected]
Phone: [phone]
Monday - Friday / 9:00AM - 5:00PM / Pacific Time
RC Vehicle is
unresponsive.
Vehicle drives slow/
poor turning.
Poor remote control
range
Low battery level Replace the batteries
Replace the batteries
Replace the batteries
Low battery level
Low battery level
Insert the batteries with the correct polarities
as shown on the battery compartment.
Remove foreign objects from the wheels
Move closer to the vehicle
Batteries are inserted incorrectly
The wheels are obstructed by
foreign objects
Vehicle is out of range from transmitter
Remove foreign objects from the wheelsThe wheels are obstructed by
foreign objects
Move to a better location with less radio
interference.
Strong radio interference from surroundings
1. Alkaline batteries are recommended to use in the transmitter.
2. Only batteries of the same or equivalent type as recommended are to be used.
3. Do not mix alkaline, standard or rechargeable batteries.
4. Do not mix old and new batteries or different types of batteries.
5. Do not recharge non rechargeable batteries.
6. If rechargeable batteries are used, only charge them under adult supervision.
7. Rechargeable batteries are to be removed from the vehicle before they are charged.
8. Be sure to insert the batteries with the correct polarities and always follow the battery
manufacturer’s instructions.
9. Remove all batteries from the vehicle and transmitter when not in use.
10.Remove exhausted batteries from the product.
11.Do no short circuit the supply terminals.
12.Dispose of batteries properly. Do not dispose of batteries in fire - it may cause the battery to
explode or leak causing injury or damage.
13.Battery change must be only made by adults.
BATTERY TIPS:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in a accordance with the instructions,
may cause harmful interference with radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC Label Compliance Statement:
WWW.WORLDTECHTOYS.COM
MADE IN CHINA
SPECIFICATIONS, COLORS AND CONTENT
MAY VARY FROM ILLUSTRATIONS
OPERATION
TIPS, TROUBLESHOOTING & MORE