20V Cordless Blower EN
76
ony on a firm, eve surface.
e) Do not operate the machine
on a paved or grave surface
where ejected materia coud
cause injury.
f) Before using, aways visuay
inspect to see, that the
fasteners are secure, the
housing is undamaged and
that guards and screens
are in pace. Repace worn
or damaged components
in sets to preserve baance.
Repace damaged or
unreadabe abes.
3)Operation
a) Before starting the machine,
make certain that the
feeding chamber is empty.
b) Keep your face and body
away from the feed intake
opening.
c) Do not aow hands or any
other part of the body or
cothing inside the feeding
chamber, discharge chute, or
near any moving part.
d) Keep proper baance and
footing at a times. Do not
overreach. Never stand at a
higher eve than the base of
the machine when feeding
materia into it.
e) Aways stand cear of the
discharge zone when
operating this machine.
f) f the machine shoud start
making any unusua noise or
vibration, immediatey shut
off the power source and
aow the machine to stop.
Remove the battery pack
from the machine and take
the foowing steps before
restarting and operating the
machine
i)inspect for damage;
ii)repace or repair any
damaged parts;
iii)check for and tighten any
oose parts.
g) Do not aow processed
materia to buid up in the
discharge zone; this may
prevent proper discharge
and can resut in kickback of
materia through the intake
opening.
h) f the machine becomes
cogged, shut-off the
power source and remove
the battery pack from the
machine before ceaning
debris.
i) Never operate the machine
with defective guards or
shieds, or without safety
devices.
j) Keep the power source
cean of debris and other
accumuations to prevent
damage to the power source
