WULF MONOLUX User manual

1
/
MONOLUX IR ILLUMINATOR
MANUAL

WHAT’S IN THE BOX
- Wulf Monolux
- Wulf Battery Charger & Cable
- Remote Dimmer Switch
- 18650 3000 mah battery
- Picatinny Rail Mount
- White LED Module
- Red LED Module
- IR850 LED Module (Pre-installed)
BATTERY INSTALLATION
1. Unscrew the rear end cap from the unit.
2. Place the fully charged battery into the
main body of the torch.
3. Screw the rear end cap back on to the
torch.
MOUNTING THE TORCH
1. Unscrew all the screws on the mount
provided.
2. Place the torch into the mount and
tighten all the screws up.
3. Attach the base of the mount to a
Picatinny/Weaver system.

OPERATION
1. Once installed and mounted, rmly press
the button on the rear of the torch to turn
on. Repeat to turn the torch o.
2. Alternatively, install the Remote Dimmer
Switch onto the back of the unit and turn
the torch on via the switch you have placed
on your rie.
3. To adjust the brightness, turn the dial on
the back of the torch OR lightly press the
Remote Dimmer Switch.
4. To adjust the focus of the beam, whilst
WARNING:
Avoid looking directly into
device when switched on.
holding the torch head, rotate the body of
the torch clockwise, this will increase the
length of the tube making the beam wider.
Please Note: On rst attempt this will be tight, so it
is recommended that you make sure the head of the
torch is on securely.

CHANGING THE LIGHT PILLS
(SOLD SEPARATELY)
1. Holding the torch in two hands, unscrew
torch head from body.
2. Unscrew the brass pill currently installed in
the unit.
3. Install desired brass pill.
4. Re-install torch head, ensuring it is on tight.
5. Operate torch as normal.
WWW.WULFOPTICS.COM
#IAMWULF