Xerox LS Duplicator 3
Table of Contents
Chapter 1: Introduction & Manual Overview........ 1-14
Beforeyoustart.................................... 1-14
PackageContents .................................. 1-16
ChapterOverview .................................. 1-16
Chapter 2: Getting to know your system............ 2-17
DuplicatorOverview................................ 2-17
LCDFrontPanel .................................... 2-18
Inputing Characters / Numbers . . . . . . . . . . . . . . . . . . . . . 2-19
Chapter 3: Basic Operations........................ 2-20
Make Disc-to-Disc Copies . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-20
Section 1: Selecting the Copy Source . . . . . . . . . . . . . 2-21
Section 2: Making Copies from Reader
(when the reader is selected as the source drive). . . 2-22
Make Hard Drive-to-Disc Copies . . . . . . . . . . . . . . . . . . . . . 2-26
Section 1: Loading Master Disc content
into the Hard Drive as a partition/image . . . . . . . . . 2-27
Section 2: Selecting the Copy Source to
theHardDrive .................................. 2-30
Section 3: Making Copies from an existing
partition/image of the Hard Drive . . . . . . . . . . . . . . . 2-31
Design and Printing Labels . . . . . . . . . . . . . . . . . . . . . . . . . . 2-35
Section 1: Design your labels with LightScribe
TemplateLabeler ............................... 2-35
Section 2: Selecting the Print Source of the
systemastheReader............................ 2-38
Section 3: Print copies of your LightScribe label
with the LightScribe Label CD you’ve created . . . . 2-39
