Xiaomi EraClean CW-BT01 User manual

User Manual for Intelligentdeodorizer
CW-BT01
Thank you for purchasing our product, for better experience, please read
carefully the above content and keep it properly.
The product is compatible with Mi Home App.
To connect with Mi Home, firstly please download and install Mi Home,
You can search Mi Home in app store to finish the step. Mi home users will
be lead to the device-connecting page by scanning the QR code in product.
Scan the QR code in product
●Add device
1.Long press the switch for 5 seconds to start the device-connecting step
(during connecting, the blue light will be on and flowing. After connected,
the blue light will be on and last for 5 secs.)
2.Open Mi Home and log in your account
3.Click the “+” in the upper right corner of the app, you’ll go to the
add-devices page
4.Click “ ” in the upper right corner of the page, scan the product
QR code and finish the step by guidance.
Notes: In case the QR code is not able to be scanned, you can add the device
by searching product name.
●As Mi Home will be updated from time to time, the actual operation might
have little differences, please follow Mi Home’s guidance to finish all
steps.
1.Product introduction

2.Use Instruction
01.Fresh mode
Click the switch once to start the fresh mode
02.Anion Mode
Click the switch twice to start the anion mode
03.Deep deodorize mode
Click the switch three times to start the deodorize mode
04.Battery indicator
Click the switch four times to check the battery capacity. If the indicator
is blue and always on, means the powers’ sufficient. If the indicator
is red and always on, means the powers’ not enough.
05.Install the hook
Install the hook in the hook hole if needed
3.Product Parameters
Product name: Intelligentdeodorizer
Model# CW-BT01
Rated voltage: 5V
Rated current:
Rated power: 2W
Battery
2A
Product
capacity: 2500mAh
dimension：158mmx48mmx39mm
N.W: 180g

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment