Xiaomi G11 User manual

Vacuum Cleaner G11 Quick Start Guide · 01
Xiaomi Vacuum Cleaner G11 Guida rapida · 08
Xiaomi Vacuum Cleaner G11 Guide de démarrage rapide
Xiaomi Vacuum Cleaner G11 Kurzanleitung
Xiaomi Vacuum Cleaner G11 Manual de inicio rápido · 29
Xiaomi Vacuum Cleaner G11 Guia de iniciação rápida · 36
Xiaomi Vacuum Cleaner G11 Руководство по началу работы
Xiaomi Vacuum Cleaner G11 Skrócona instrukcja obsługi · 50
Xiaomi Vacuum Cleaner G11 Hızlı Başlangıç Kılavuzu · 57
· 43
· 15
· 22

1
Precautions
Do not directly rinse the vacuum cleaner, electric tangle-free brush bar, or
electric mite brush with water.
Do not vacuum burning or smoking substances such as unextinguished
cigaree bus, or hard or sharp objects like nails. To prevent injury, do not
touch rotating parts while the vacuum cleaner is running.
Do not vacuum any liquids.
Do not charge or store the vacuum cleaner near heat sources or in humid areas,
such as by a radiator or in a kitchen or bathroom.

2
Installing the Accessories onto the Vacuum Cleaner
Installation
Click into Place Click into Place
Electric Tangle-free Brush Bar
Brush Nozzle Crevice Nozzle Electric Mite Brush

3
Press and hold the buon for 3 seconds to open the language list, then
press the buon to scroll through the language to select the desired one.
To use the selected language, press and hold the buon for 3 seconds or no
operation for 5 seconds.
Press to switch the language.
Baery Status Indicator
Suction Level/
Language Buon
Status Display
Lock Buon
Display Functions
Seing Language
Auto
English
English
English

4
Using the electric tangle-free brush bar can help to prevent the hair from
geing tangled on the roller brush, reducing the maintenance frequency and
extending the service life of the vacuum cleaner.
How to Use
Using the Power Buon to Turn On the Vacuum
Press the buon to enable Continuous Mode, then press the power buon
to turn the vacuum cleaner on. To exit Continuous Mode, press the buon.
Enabling the Continuous Mode allows the vacuum cleaner to run continuously
without having to hold down the power buon, which can help release your
fingers.
Press the buon to enable Continuous Mode, then press the power buon
to start the vacuum cleaner. Press the power buon again to stop it.
Switching Suction Levels
Auto Mode is enabled by default. In this mode, the vacuum cleaner
automatically adjusts its suction level and brush speed depending on surface
type and dust compartment capacity.
Press the buon to cycle through the vacuum cleaner's suction levels: Auto
(recommended), Turbo, and Eco.
* The Auto and Eco levels are sufficient for most routine cleanings.
Power Buon
* It is normal for the roller brush to accumulate small amounts of hair over time. There is a
motor contained in the electric tangle-free brush bar, which can help to cut hairs tangled
on the roller brush. The motor runs periodically and aer it runs continuously for a period of
time, the tangled hair will be cut away automatically.

5
Hold the dust compartment over a trash bin, then press the dust release
buon.
Rotate and remove the dust compartment, then clean the sensor area with a
so dry cloth.
Easy-to-empty Dust Compartment
Cleaning the Dust Sensor
Press firmly to close the dust compartment.
Routine Cleaning
Dust Sensor

6
Cleaning the Filter Assembly
Remove the filter assembly from the dust compartment, then unscrew the filter
from the pre-filter and remove the sponge filter from the filter.
Rinse the dust compartment, pre-filter, filter, and sponge filter under running
tap water until clean, then set aside all parts to fully dry for at least 24 hours.
Do not touch the surface of the filter or sponge filter with a brush or sharp
object to avoid damage.
Do not immerse the filter in water.
* Clean the filter, then rinse it out and lightly tap on the edge of the filter to remove dust and
debris.
Care & Maintenance
Pre-filter
Fliter Sponge Filter
24h

7
If the vacuum cleaner is not working properly, the display will show an error message. Please refer to the troubleshooting table below to find your solution based on the
error message.
For more information on how to clean parts, please refer to the Care & Maintenance section of the user manual.
Note: Illustrations of the product, accessories, and user interface are for reference purposes only. Actual product and functions may vary due to product enhancements.
Status Errors
Error Icon Error Message Solution
Airway Blocked Clear any blockages from the dust compartment, pre-filter, filter, extension
rod, brush bar, and nozzle.
Roller Brush Stuck Remove any debris or objects clogged or tangled on the roller brush.
Low Baery Recharge soon.
Baery Depleted Recharge soon.
Baery Overheated Wait until the baery temperature normalizes, then resume use.
Clean the Sensor Wipe away dust from the sensor using a dry cloth or paper towel.
Filter/Dust Compartment Error Filter is not installed correctly, or dust compartment is not closed securely or
installed. Please install them properly.
Power Supply Error Only use the genuine power supply to charge the vacuum cleaner.
Error Code Please contact aer-sales service to arrange maintenance.

8
Precauzione
Non risciacquare direamente con acqua l'aspirapolvere, la spazzola elerica
anti-grovigli o la spazzola elerica per acari.
Non aspirare sostanze che bruciano o fumano (ad es. mozziconi di sigarea
non spenti), né oggei duri o taglienti (ad es. chiodi). Per evitare lesioni, non
toccare le parti rotanti quando l'aspirapolvere è in funzione.
Non aspirare liquidi.
Non ricaricare né riporre l'aspirapolvere vicino a fonti di calore o in zone umide
(ad es. vicino a un termosifone o in cucina o in bagno).

9
Installazione degli accessori nell'aspirapolvere
Installazione
Far scaare in posizione Far scaare in posizione
Spazzola elerica anti-grovigli
Bocchea a spazzola Bocchea a lancia
(per fessure)
Spazzola elerica
per acari