XL displays FUGU User manual

®

INFLATABLE CHAIR

’s advice:
Inflate the furniture
to 30%. Then add the
customised cover and
inflate fully.

ValVe
3) Check Valve
1) Access to the air tank
2) Ring
4) Cap
Screw the cap.
Close the check valve and
finish inflation.
LIGHTING option
Insert a LED lamp inside the plastic pocket.
Turn it on with the remote control.
Inflate the furniture at
60% with the access to
the air tank. Then reajust
the cover easily.

FUGU INFLATABLE chair
1) See the location of the
valve.
2) Lay down the chair and its
cover on the floor, inflate
partially then.
COVERCHAIR
3) Place the plastic
bladder as the
drawing below.
4) Put the cover string in the
eyelets of the structure.
5) Finish covering the
plastic bladder.
5 Place
the cover
properly.
7 Screw
the cap.
6 Close the
check valve and
finish inflating.
5) Tighten strong and
make a knot.
INNER COVER
OUTTER COVER

REPAIRS
The fugu furniture has to be inflated to making repairs.
Holes bigger than 2cm cannot be repaired.
Do not use the Airflower for 48 hours after any repairs.
!
2 Take the glue and
the plastic patch out
of the plastic bag.
3 Cut out a circle
that is twice the size
of the hole.
4 Carefully apply
some glue on the
hole.
1 Inflate
the chair.
5 Immediately
place the patch
over the hole.
7 Remove all air
bubbles and glue
residue around the
patch.
6 Press the patch
for a few minutes
4 Gently spread the glue
before it dries
(30 seconds).
2 Take the glue out
of the plastic bag.
3 Carefully apply some
glue on the hole.
5 Do not use too
much glue to avoid
ugly residue.
No
1 Inflate
the chair.
IF THERE IS
A HOLE
IF THERE IS A
HOLE ATTHE
JOINT