Kit includes: Top, front, back, 2x sides, 2x shelves, 8x turn parts and 2 x hand wheel
nuts. Foam tape suppled but not applied ( The above kit shown is a deluxe kit)
To build the base of the unit
align front with the locators
on the sides, Screw the
turn parts through the front
and into the side panel.
Repeat this for the
remaining sides
Insert the smaller of the two
shelves at the bottom of the
unit. Rest the shelf on the
shelf locator. Repeat these
steps with the upper
shelf.Please note: 8
screws are supplied to fix
shelves permanently
Lift the top onto the base of
the unit
Lower the table top onto the
base of the unit. Make sure
the table top locators are in
the locators on the sides of
the unit.
Once the table top is in
place secure using hand
wheel
Replace the top set of turn
parts on the front of the
counter with the stand off kit
Optional extra fascia kit
Place the locators of the
facia onto the stands off
kits
Screw down the top of the
stand off’s to secure into
place.
Ensure top of side is
aligned/Parallel with
front/rear face.
Please note: The adhesive
dot indicates the top.
www.xldisplays.co.uk
01733 511 030
V-Counter - Standard and Deluxe
Assembly Instructions
