XMG OASIS Manual

Page 1 of 5
XMG OASIS - Disassembly Procedures
⚠WARNING ⚠
In the event of a defect or for any other purpose, we do NOT recommend disassembling the device!
• The internal structures of the device can be quite delicate.
• Any mistakes during disassembly and reassembly may cause material failure, leading to future leakage.
• Any defects that are caused by inappropriate disassembly, mechanical damage, chassis modifications or
swapping out parts may void your warranty.
In the event of technical problems or defects, please contact our support team first.
Spare parts
We are able to ship spare parts such as tubes and connectors to fulfill our warranty agreement and for any
after-warranty service. If you wish to order a spare part, please contact our support team with a picture of
the part you wish to order.

Page 2 of 5
1. Unfasten four screws and
take out the bottom base.
Electric screw driver torque values for all steps except fan removal:
•1.5±0.2 kgf.cm
•PH 1 screwdriver bit
2. Unfasten six screws.
3. Unfasten six screws and
take out the outer frame

Page 3 of 5
4. Remove the plastic cap and
take out the two nuts.
5. Unfasten four screws &
cable, take out the front cover

Page 4of 5
6. Unfasten four screws &
cable, take out the bracket
7. Unfasten seven screws &
cable, take out the water box

Page 5 of 5
8. Unfasten three screws &
cable, take out the fan
module
9. Unfasten four screws &
cable, take out the fan
electric screw driver torque
values for only this step:
3.0±0.2 kgf.cm
10.Unfasten six screws &
cable, take out the M/B
torque back to 1.5±0.2 kgf.cm