XTA MC2 Operating instructions

Dpanel8 Short form Programming Guide
Introduction
Welcome to the short programming guide for the XTA / Mc2 D-Panel8.
This short guide gives an overview how to program the Dpanel8.
The panel configuration is designed using the control software downloadable below
https://audiocore.wpengine.com/wp-content/uploads/2019/04/DPanel-Utilities.zip
The software is pictured at the top of this page :
The design files this software creates is an *.xtawpnl file.
To program the wall panel it needs connecting to a Mc2 delta dsp
or XTA DPA amplifier.
Please ensure
1) an ethernet connection from PC to the amplifier is made.
2) The amplifier interface is set to `ethernet`
& `Rs485 mode` is set to `simple` & `115200`.
Please see the wiring guide on page 2,
This shows how your panel needs connecting to your amplifier.
This connection works for both programming and panel control.
The standard XTA loader is then used to load the *.xtapnl file.
Page 1 of 2
PROGRAMMABLE REMOTE PANEL PRP-200
tax
KEY
4
KEY
8
KEY
7
KEY
3
KEY
6
KEY
2
KEY
5
KEY
1
RELAY

PROGRAMMABLE REMOTE PANEL PRP-200
tax
KEY
4
KEY
8
KEY
7
KEY
3
KEY
6
KEY
2
KEY
5
KEY
1
RELAY
Dpanel8 Short form Programming Guide
Run the XTA loader.
Press the Connect button.
The loader finds the amp.
Press `....` & select your *.xtapnl design file.
Press buttons 1,2,3,4 together this puts the
panel in programming mode. (see pic with
key numbers on the right )
In programming mode you get disco lights on
the panel.
Whilst the button lights flash now press Load.
Loader now loads panel...
Voila remote control begins.
When the amp receives a command it
tells you on its display.
More detailed information can be found here
https://audiocore.wpengine.com/wp-content/
uploads/2019/06/Combined-XTA-MC-App-Note
-D-Panel8-Overview-Rev1.pdf
Page 2 of 2