Xylem SH-BLOX-OT24 Series User manual

TM
TM
INSTALLATION INSTRUCTIONS
BLOX
CONSOLE
SH-BLOX-OTxxXX
THANK YOU FOR CHOOSING XYLEM
Please take a few minutes to review this manual before you start installation. If you encounter any installation problems, please don’t
hesitate to contact us. Before you begin, please observe all local building codes. Unpack the new product and inspect for damage.
The appearance of your vanity may differ from the illustrations in this guide.This instructions still apply. Please ensure the finished wall
is straight and plumb and the floor is flat and perpendicular to the finished wall.
ROUGH-IN DIMENSIONS
SUGGESTED TOOLS AND MATERIALS
Philips Screwdriver Level Drill Tape Measure Safety Glasses
10'
SH-BLOX-OT30XX
SH-BLOX-OT24XX SH-BLOX-OT36XX SH-BLOX-OT48XX
SH-BLOX-OT24XX 24”
SH-BLOX-OT30XX 30”
SH-BLOX-OT36XX 36”
SH-BLOX-OT48XX 48”
Model # X (inch)
FLOOR
FINISHED
WALL
Y (inch)
3-7/8” (100mm)
Undermount
Vessel
Application Y (inch)
28.5”
25.5”
SUGGESTED HEIGHT:
5-1/2”
(140mm)
X 21-1/2” (546mm)

CARE AND CLEANING
2” x 6”
Header
WALL PREPARATION
Finished Wall
Z
Notch studs 1-1/2" (38mm) to
provide support for header.
Extend the header beyond the
countertop to the nearest stud.
INSTALLATION INSTRUCTIONS
BLS01
HARDWARE INCLUDED
x 8
For customer support please visit www.xylem.biz or call 866 395 8112 weekdays 8:00 to 5:00 EST or fax [phone] any time
Rev 2/10
Level the vanity with a leveler and attach
the brackets to the 2 x 12 header using
screws provided.
Undermount
Vessel
Application Z (inch)
35”
32”
SUGGESTED HEIGHT:
• To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading.Also avoid extreme
changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning units. Avoid placing furniture
directly under windows.
• Dust the vanity frequently with a clean, soft, dry or lint-free cloth. Clean the surface by rubbing in the direction of the grain using damp
lint-free cloth. Avoid using silicone cleaners and waxes.
• Clean up excess water and spills immediately. Use blotting rather than a wiping action. Water left over a long period of time will cause
white spots in the finish. Please note that some chemicals may damage the finish.