XYZ Printing da Vinci 1.0 User manual

da Vinci 1.0 User Manual
P 1

da Vinci 1.0 User Manual
P 2

da Vinci 1.0 User Manual
P 3

da Vinci 1.0 User Manual
P 4

da Vinci 1.0 User Manual
P 5

da Vinci 1.0 User Manual
P 6
A
B
Packing support x2
Tapex2
Cable tie x1
GLUESTICK
PRINTING
Open the box
23
6
57
8
9
1
4
A
B
Open the top cover, then remove
packaging supports and tapes from
inside.
Remove the print bed shipping tapes and
foam cushioning pieces.
Remove the bottom screw and the
plastic piece under print bed.
Remove the drip tray packaging
tapes.
Open the box and
remove the accessories
and the cushion.
Take out the printer
by holding the side
handles.
Remove plastic
bag and tapes.
Remove the cardboard.
Use the USB cable to connect the
printer to PC. Connect the power
cord to the printer then turn on the
power switch.
Note: Cable tie illustrated in step 4 in this section is used to fix the extruder during transportation.
It should be removed before powering on the printer, or the printer may not funtion normally.

da Vinci 1.0 User Manual
P 7
GLUE STICK
．Filament Cartridge
．Power Cord
．USB Cable
．Decorative Plate x2
．Software CD
．User Quick Guide
．Cartridge Locker
．Glue Stick
PRINTING
．Copper Brush
．Cleaning Wire x5
．Scraper

da Vinci 1.0 User Manual
P 8

da Vinci 1.0 User Manual
P 9
Display Panel

da Vinci 1.0 User Manual
P 10

da Vinci 1.0 User Manual
P 11

da Vinci 1.0 User Manual
P 12

da Vinci 1.0 User Manual
P 13

da Vinci 1.0 User Manual
P 14

da Vinci 1.0 User Manual
P 15

da Vinci 1.0 User Manual
P 16

da Vinci 1.0 User Manual
P 17

da Vinci 1.0 User Manual
P 18

da Vinci 1.0 User Manual
P 19

da Vinci 1.0 User Manual
P 20