Operation
Smoke Detection
When smoke is detected the device will activate
for a minimum of 10 seconds with a two tone
alarm and flashing LED. The Detector will send
a radio signal to the Control Panel, Siren or
Smart Hub (Depending on your Alarm system).
• Pressing the test button when in an alarm
condition will silence the alarm for 10
minutes. It will automatically resume smoke
detection again after this period.
Testing
• Smoke Detector testing should be done on
a regular monthly basis. Pressing the test
button will make the LED flash, the audible
sounder chime and will send a radio test
signal to the Control Panel, Siren or Smart
Hub when the button is released. If nothing
happens after pressing the test button, it
indicates the batteries will need changing.
Recalibration
• The Smoke Detector might need recalibrating
after time to ensure it is working at its
optimum. This is done by pressing and
holding the test button until the LED flashes
and beeps after 10 seconds. The Detector
will then start its self calibration routine.
Specification
Environmental conditions:
-10c to 40c , relative humidity 85%
non-condensing. Indoor use only
Radio:
868MHz FM
Compatible with Yale ‘SR’ and ‘EF’
Alarm Kits.
Note: Waste electrical products and batteries should not be disposed
of with household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice.
Issue No. 1A
Information and illustrations are subject to change.
Yale reserves the right to alter the specification and
product design at any time without notice.
