Yamaha D24 User manual

Owner’s Manual
DIGITAL MULTITRACK RECORDER
00 00 00 00
YAMAHA D24
OVER
READY
0
2
6
10 12
14 20
18 30
20 42
26 60
–dB
OVER ABS H
LOCK
TIME DISPLAY
CAPTURE ABS/REL REMAIN
VARI
SPEED UTILITY SETUP
PROJECT
SELECT
LOC MEM
RECALL
LOC MEM
STORE
LOCATEENTERCANCEL
0/-
1
4
7
8
R
7654321
RECORD
READY
SOLO/
SELECT
MONITOR SELECT
PEAK
HOLD AUTO INPUT ALL INPUT FORMAT CHASE
L
2
5
8
3
6
9
UNDO/
REDO
EDIT
JOG ON
JOG/DATA SHUTTLE/
CURSOR
PROJECT SEARCH
RTN TO
ZERO
REW FF STOP PLAY REC
ROLL
BACK
LAST REC SET
DIGITAL MULTITRACK RECORDER
REPEAT REHE
PHONES
LEVEL
010
ON
POWER
OFF
PHONES
BA
B
A
AUTO
PUNCH
IN OUT
INT 24 48K
MASTER
WC
BIT FS TC
MSF
READY
0
2
6
12
20
30
42
60
–dB
V. TRA CK
SELECT
E
Keep This Manual For Future Reference.

ADVARSEL!
Lithiumbatteri—Eksplosionsfare ved fejlagtig
håndtering. Udskiftning må kun ske med batteri
af samme fabrikat og type. Levér det brugte
batteri tilbage til leverandoren.
VARNING
Explosionsfara vid felaktigt batteribyte. Använd
samma batterityp eller en ekvivalent typ som
rekommenderas av apparattillverkaren.
Kassera använt batteri enligt fabrikantens
instruktion.
VAROITUS
Paristo voi räjähtää, jos se on virheellisesti
asennettu. Vaihda paristo ainoastaan
laitevalmistajan suosittelemaan tyyppiin. Hävitä
käytetty paristo valmistajan ohjeiden
mukaisesti.
WARNING: THIS APPARATUS MUST BE EARTHED
IMPORTANT
THE WIRES IN THIS MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE:
GREEN-AND-YELLOW : EARTH
BLUE : NEUTRAL
BROWN : LIVE
As the colours of the wires in the mains lead of this apparatus may
not correspond with the coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured GREEN and YELLOW must be
connected to the terminal in the plug which is marked by the letter E
or by the safety earth symbol or coloured GREEN and YELLOW.
The wire which is coloured BLUE must be connected to the terminal
which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the
terminal which is marked with the letter L or coloured RED.
* This applies only to products distributed by YAMAHA KEMBLE
MUSIC (U.K.) LTD.
NEDERLAND THE NETHERLANDS
●Dit apparaat bevat een lithium batterij voor geheugen
back-up.
●Raadpleeg uw leverancier over de verwijdering van de
batterij op het moment dat u het apparaat ann het einde
van de levensduur afdankt of de volgende Yamaha Service
Afdeiing:
Yamaha Music Nederland Service Afdeiing
Kanaalweg 18-G, 3526 KL UTRECHT
Tel. [phone]
●Gooi de batterij niet weg, maar lever hem in als KCA.
●This apparatus contains a lithium battery for memory
back-up.
●For the removal of the battery at the moment of the
disposal at the end of the service life please consult your
retailer or Yamaha Service Center as follows:
Yamaha Music Nederland Service Center
Address: Kanaalweg 18-G, 3526 KL
UTRECHT
Tel: [phone]
●Do not throw away the battery. Instead, hand it in as small
chemical waste.
FCC INFORMATION (U.S.A.)
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC
requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.
2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST
be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA.
3. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital devices. Compliance with
these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with
other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may
cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee that interference will not occur in all
installations. If this product is found to be the source of interference, which can be determined by turning the unit “OFF” and “ON”, please try to eliminate the
problem by using one of the following measures: Relocate either this product or the device that is being affected by the interference. Utilize power outlets that are on
different branch (circuit breaker or fuse) circuits or install AC line filter/s. In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in
is 300 ohm ribbon lead, change the lead-in to coaxial type cable. If these corrective measures do not produce satisfactory results, please contact the local retailer
authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service
Division, 6600 Orangethorpe Ave, Buena Park, CA 90620
The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.

Laser Diode Properties
* Material : AlGaInP
* Wavelength : 675–695 nm
* Emission Duration : Continuous
* Laser Output Power : Less than 44.6 µW
Laser output is measured at a
distance of 20 cm from the object
lens on the optical pick-up head.
(Note)
•These labels are
located on the interior.
•Varningsanvisning för
laserstrålning. Placerad
i apparaten.
This unit is classified as a
Class 1 laser product.
This label is located on the
exterior.
CLASS 1 LASER PRODUCT
LUOKAN 1 LASERLAITE
KLASS 1 LASERAPPARAT Klassmärkning för Finland.
CAUTION
USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED HEREIN MAY RESULT
IN HAZARDOUS RADIATION EXPOSURE.
ADVARSEL
Usynlig laserstråling ved åbning. Undgåudsaettelse
for stråling.
VAROITUS
Laitteen käyttäminen muulla kuin tässäkäyttöohjeesa
mainitulla tavalla saattaa altistaa käyttäjän
turvallisuusluokan 1 ylittävälle näkymättömälle
lasersäteilylle.
VARNING
Om apparaten används påannat sätt än i denna
bruksanvisning specificerats, kan användaren utsättas
för osynlig laserstrålning, som överskrider gränsen för
laserklass 1.
DANGER
INVISIBLE LASER RADIATION WHEN OPEN.
AVOID DIRECT EXPOSURE TO BEAM.
DANGER
RADIATIONS INVISIBLES DU LASER EN CAS D' OUVERTURE.
EVITER TOUTE EXPOSITION DIRECTE AU FAISCEAU.
VORSICHT
LASERSTRAHLUNG. WENN ABDECKUNG GEÖFFNET
NICHT DEM STRAHL AUSSETZEN.
ADVARSEL
USYNLIG LASERSTRÅLING VED ÅBNING NÅR
SIKKERHEDSAFBRYDERE ER UDE AF FUNKTION.
UNDGÅUDSAETTELSE FOR STRÅLING.
VARNING
OSYNLIG LASERSTRÅLNING NÄR
DENNA DEL ÄR ÖPPEND. STRÅLEN
ÄR FARLIG.
APL

i
D24—Owner’s Manual
Important Information
Read the Following Before Operating the D24
Warnings
• Do not subject the D24 to extreme temperatures, humidity, direct sunlight, or dust,
which could be a potential fire or electrical shock hazard.
• Connect the D24 power cord to an AC outlet of the type stated in this Owner’s Manual
or as indicated on the D24. Failure to do so is a fire and electrical shock hazard.
• Do not plug several devices into the same AC outlet. This may overload the AC outlet,
and could be a fire or electrical shock hazard. It may also affect the performance of some
devices.
• Do not place heavy objects on the power cord.A damaged power cord is a potential fire
and electrical shock hazard.
• If the power cord is damaged (e.g., cut or a bare wire is exposed), ask your dealer for a
replacement. Using the D24 with a damaged power cord is a fire and shock hazard.
• Hold the power cord plug when disconnecting from an AC outlet. Never pull the cord.
A power cord damaged through pulling is a potential fire and electrical shock hazard.
• Do not place small metal objects on top of the D24. Metal objects falling inside the D24
is a fire and electrical shock hazard.
• Do not block the D24 ventilation slots. The D24 has ventilation slots at the side and a
cooling fan at the rear to keep the internal components cool. Blocking the ventilation
slots or obstructing the fan’s airflow is a potential fire hazard.
• Do not attempt to modify the D24. This is a potential fire and electrical shock hazard.
• The D24 operating temperature is between 5˚C and 35˚C (41˚F and 95˚F).
Cautions
• Allow enough free space around the unit for normal ventilation. This should be: 10 cm
behind and 20 cm above.
These distances should also be adopted when rack-mounting the unit. For normal ven-
tilation during use, remove the rear of the rack or open a ventilation hole.
If the airflow is not adequate, the unit will heat up inside and may cause a fire.
• Turn off audio devices when connecting them to the D24, and use only the cables spec-
ified in the relevant owner’s manuals.
• If you notice any abnormality—such as smoke, odor, or noise—turn off the D24 imme-
diately. Remove the power cord from the AC outlet. Confirm that the abnormality is no
longer present. Using the D24 in this condition is a potential fire and shock hazard.
Consult your dealer for repair.
• If a foreign object or water gets inside the D24, turn it off immediately. Remove the
power cord from the AC outlet. Using the D24 in this condition is a potential fire and
electrical shock hazard. Consult your dealer for repair.
• If you plan not to use the D24 for a long period of time, remove the power cord from
the AC outlet. Leaving the D24 connected is a potential fire hazard.
• Do not use benzene, thinner, cleaning detergent, or a chemical cloth to clean the D24.
Use only a soft, dry cloth.

ii
D24—Owner’s Manual
MO Disks
• Use only MO disks of the type specified in this manual.
• Store MO disks in a place free from extreme temperatures, humidity, dust, and dirt.
• Do not slide open the MO disk shutter, and never touch the actual disk.
• If an MO disk is stored in a cold place (e.g., overnight in a car), and then moved to a
warmer environment, condensation may form on the disk. In this case, the disk should
be left to acclimatize for about 30 minutes before use.
Interference
The D24 uses high-frequency digital circuits that may cause interference on radio and
television equipment located nearby. If interference is a problem, relocate the affected
equipment.
D24 Exclusion of Certain Responsibility
Manufacturer, importer, or dealer shall not be liable for any incidental damages includ-
ing personal injury or any other damages caused by improper use or operation of the
D24.
Package Contents
The D24 package should contain the following items. Contact your Yamaha dealer if
you are missing an item.
• D24 Digital Multitrack Recorder
• This manual
•Powercord
• MO disk
• Disk eject tool
Trademarks
ADAT MultiChannel Optical Digital Interface is a trademark and ADAT and Alesis are
registered trademarks of Alesis Corporation.Apple and Macintosh are registered trade-
marks of Apple Computer, Inc. Digidesign and OMF are registered trademarks and
Sound Designer II is a trademark of Avid Technology, Inc. Tascam Digital Interface is a
trademark and Tascam and Teac are registered trademarks of Teac Corporation.
MS-DOS is a registered trademark and Windows is a trademark of Microsoft Corpora-
tion.Yamaha is a trademark of Yamaha Corporation.All other trademarks are the prop-
erty of their respective holders and are hereby acknowledged.
Copyright
No part of the D24 software or this Owner’s Manual may be reproduced or distributed
in any form or by any means without the prior written authorization of Yamaha Cor-
poration.
© 1999 Yamaha Corporation. All rights reserved.