Yamaha ATS-C200 User manual

En 1
EN
Quick Start Guide
Sound Bar
About this Quick Start Guide
This document provides step-by-step instructions for installation and
playback. Refer to the User Guide on the Yamaha website for more
information.
Visit the following website to see the latest User Guide.
https://manual.yamaha.com/av/20/atsc200/
Thank you for purchasing this Yamaha product.
• To use this product properly and safely, read this Quick Start
Guide and the supplied booklet “Safety Brochure” before using
the unit.
• After reading this document and the Safety Brochure, be sure to
keep them in a safe place where they can be referenced at any
time.

2 En
Make sure you have received all of the following accessories:
Supplied accessories
Sound bar (ATS-C200)
Spacers (A: ×2, B: ×2 on 1 sheet)
Remote control
Use when mounting the sound bar on a wall.
Mounting template
Power cord
NOTE
An HDMI cable is not included with this sound bar. Please
consider length when purchasing this cable separately.
Digital optical audio cable
• Quick Start Guide (this booklet)
• Safety Brochure
AC adaptor
(model number: ANAD-420FIOT-B
or ANAD-420FIOT-W)

En 3
Remove the battery insulating strip before attempting to use the
remote control.
NOTE
A Lithium battery (CR2025) has already been inserted into the remote
control.
Operating range of the remote control
Use the remote control within the range shown in the following
illustration:
Installed on a TV stand
Wall-mounted
Preparing the remote control
Battery insulating strip
Within 6 m (20 ft)
Remote control
sensor
Installing the sound bar
Refer to the User Guide. When installation
and all connections are complete, power off
sound bar and hold down BASS EXT on the
sound bar's remote control for at least five
seconds. The frequency characteristics are
configured for wall mount installation.
Controls
Controls
User Guide

4 En
Depending on the type of TV, connect the TV to the sound bar as follows:
Connect the TV using an ARC-compatible HDMI cable (sold
separately).
Connect the TV using an HDMI cable (sold separately) and digital
optical audio cable (supplied). Be sure to use both cables to connect
the TV.
Connecting a TV
Is your TV equipped with an HDMI jack labeled as “ARC?”
Yes No
HDMI INOPTICAL
HDMI
HDMI
ARC
Sound bar (rear)
HDMI OUT/
TV (ARC)
input
ARC-compatible TV ARC-compatible
HDMI input
HDMI INOPTICAL
HDMI
HDMI
OO
O
O
Sound bar (rear)
HDMI
OUT/TV
(ARC)
input
TV HDMI input
TV input
Audio output
(Digital
optical audio)
1. Remove the cap.
2. Check the orientation
of the plug.

En 5
NOTE
• When the sound bar is connected to a TV via HDMI cable, confirm
that the TV’s settings are properly configured as follows:
– The TV's HDMI Control function is enabled.
– The TV’s audio output is set to ARC. (When an ARC-compatible
TV is used.)
• The TV’s HDMI Control function allows for controlling the following
functions using the TV’s remote control:
– Turn the power on and off
Both the TV and the sound bar turn on/off at the same time.
– Volume adjustment
The sound bar’s volume can be adjusted when the TV’s audio
output is set to the sound bar.
Connecting the TV using only the digital
optical audio cable (supplied)
When the HDMI Control function is not used or the TV is not
equipped with an HDMI input jack, connect the TV as follows:
OPTICAL
OO
O
O
Sound bar (rear)
TV
TV input
Audio output
(Digital optical audio)
1. Remove the cap.
2. Check the orientation
of the plug.