Yolink YS3603-UC User manual

YoL ink Rem ote
Quick Start Guide
YS3603-UC
Scan QR-Code
for User Guide
For more information, please
visit www.yosmart.com.

Introduction
ON
ALL ON
OFF
ALL OFF
Green Once
Trigger an act ion.
Fast Blinking Green
Set up co nnection wit h devices.
Fast Blinking Red
Remov e connection w ith devices.
Blinking Red and Green Alternately
Facto ry resetting .
BATTERY COVER

Pairing
Find a YoLink remote as controller(Master). Hold
any ON button for 5-10 seconds, the light will
flash green quickly.
Find an action device as responder(Receiver).
Hold the power/set button for 5-10 seconds, the
device will enter the pairing mode.
After pairing succeed, the light will stop flashing.
When press the ON button or ALL ON button on
the remote, the action device will turn on. When
press the corresponding OFF button or ALL OFF
button on the remote, the action device will turn off.
ON

Un-pairing
Find the controller(Master) YoLink remote. Hold
the OFF button for 10-15 seconds, the light will
flash red quickly.
Find the r esp ond er( Receiver) action d evi ce.
Hold the power /se t bu tton for 10-15 seconds,
the device wil l en ter the un-pairing mode.
The above two devices will unpair by themselves
and the light stops flashing.
After unbundling, all the control button will no
longer change status of the device.
OFF