Yutrax TX158 User manual

Owner's Manual
TX158 Two-Wheel
ATV Trailer
Rated Capacity - 1250lb
GAS/OIL
RATIO
50:1
P/N: 22316
REV2: 12/14/18
© 2018 RETI
All Rights Reserved.
Get parts online at
www.yutrax.com

Owner's Manual
TX158 ATV Trailer
Check for parts online at www.yutrax.com or call 800-345-6007 M-F 8-5 CSTPage 2
ASSEMBLY TIP
FOR EASIER ASSEMBLY, PLACE UNIT
UPSIDE DOWN THROUGH STEP 8.
WARNING
READ, UNDERSTAND AND FOLLOW ALL ASSEMBLY,
INSPECTION, MAINTENANCE & USE INSTRUCTIONS
PROVIDED BEFORE EACH USE. FAILURE TO FOLLOW
ALL WARNINGS AND INSTRUCTIONS COULD RESULT IN
SERIOUS INJURY OR DEATH.
BE SURE TO FOLLOW ALL INSTRUCTIONS PROVIDED. IF
ANY INSTRUCTIONS ARE NOT UNDERSTOOD OR IF YOU
HAVE A PARTS ISSUE, CALL 8003456007 BEFORE USING.
THE WHEEL BEARINGS ARE NOT FACTORY GREASED.
YOU MUST GREASE THE BEARINGS BEFORE USE. CHECK
GREASE LEVEL FREQUENTLY TO PREVENT BEARINGS
FROM SEIZING.
DOUBLE CHECK THE ASSEMBLY OF YOUR TRAILER TO BE
SURE YOU ASSEMBLED IT CORRECTLY AND ALL NUT &
BOLT ASSEMBLIES ARE TIGHT BEFORE INITIAL USE.
BE SURE TO PERIODICALLY CHECK ALL NUT AND BOLTS
FOR TIGHTNESS. OVER TIME, NUTS AND BOLTS MAY
BECOME LOOSE FROM VIBRATION.
BE SURE TO ALWAYS HAVE THE CORRECT AMOUNT OF
AIR PRESSURE IN TIRES. THIS WILL HELP DETER FROM
UNNECESSARY WEAR AND/OR DAMAGE. AIR PRESSURE
CAN BE FOUND ON SIDEWALL OF TIRE.
NEVER DRIVE ON HILLY TERRAIN  EXCESSIVE WEIGHT
CAN CAUSE WEIGHT SHIFTS WHICH CAN LEAD TO LOSS OF
CONTROL OF YOUR ATV AND/OR ATV TRAILER.
DO NOT DRIVE IN EXCESS OF 10 MPH WHILE USING THIS
PRODUCT.
NEVER ALLOW PEOPLE OR ANIMALS TO RIDE IN THE ATV
TRAILER! IT IS NOT DESIGNED FOR THAT MATTER.
USE CAUTION NEARTRAILERTILT LATCH.BE SURE LATCH IS
ENGAGED BEFORE EACH USE.
NEVER EXCEEDTHE MAXIMUM WEIGHT CAPACITY OF 1250
LB OF EVENLY DISTRIBUTED WEIGHT.
YUTRAX™ offers a full line of ATV accessories. We appreciate your purchase of our world class ATV Trailers. Follow these few simple
instructions and your product will be sure to give you many years of trouble free pleasure. Instructions should be kept in a safe
place and reviewed at least annually.
If for any reason you have a problem with your product, DO NOT return to the retailer; contact the YUTRAX™ customer service
department Monday through Friday from 8 a.m. to 5 p.m. CST at 800-345-6007 for assistance.
FIGURE 1
16
19
24
23
2
1
ASSEMBLY INSTRUCTIONS:
Tools needed -- two 10mm wrenches, two 13mm wrenches,
20mm socket with ratchet & extension, needle nose pliers and
a grease gun.
IMPORTANT ASSEMBLY TIPS:
Do not tighten any nut and bolt combinations completely
until all parts are assembled together! Finger tighten plus
one turn of a wrench only! This will temporarily hold the
lock nut on the bolt while helping alignment of all parts!
After all parts are assembled together, all nut & bolt
combinations must be completely tightened.
Do initial assembly steps with the trailer frame parts
oriented upside down, this will aid in the assembly.
1. Secure the sides of the front trailer frame (1) to the sides
of the rear trailer frame (2) using two M6x50mm bolts (24),
M6 steel washers (16) and M6 locknuts (19). SEE FIGURE 1
2. Secure the bottom of the front trailer frame (1) to the
bottom of the rear trailer frame (2) using two M6x65mm
bolts (23), M6 steel washers (16) and M6 locknuts (19).
SEE FIGURE 1

Check for parts online at www.yutrax.com or call 800-345-6007 M-F 8-5 CST Page 3
Owner's Manual
TX158 ATV Trailer
FIGURE 2
16
19
26 4
24
FIGURE 3
7
5
21
18
15
10
20
12
11
22
FIGURE 4
6
4
5
25
19
3. Attach the top of the two axle mounting plates (4) to the
trailer frame assembly with four M6x40mm bolts (26),
M6 steel washers (16) and M6 locknuts (19). Then, secure
the bottoms of the two axle mounting plates (4) using
four M6x50mm bolts (24), M6 steel washers (16) and M6
locknuts (19). SEE FIGURE 2
4. Insert rear tongue tube (7) into the "u-bracket" on the axle
tube (5) and secure with one M8x70mm bolt (21), M8 steel
washer (15) and M8 locknut (18). SEE FIGURE 3
5. Secure the latch tube assembly (10) to the top of the rear
tongue tube (7) with two M8x100mm bolts (20), M8 steel
washers (15) and M8 locknuts (18). SEE FIGURE 3
6. Insert the latch tube assembly (10) and the front tongue
tube (12) into the connector pocket (11) and secure with
two M8x60mm bolts (22), M8 steel washers (15) and M8
locknuts (18). SEE FIGURE 3
7. Attach the tongue assembly to the frame assembly by in-
serting the short end of the two axle spindles (6) through
the axle mounting plates (4) and threading into the axle
tube (5). Thread axle spindles until snug and then loosen
until holes in the axle tube and spindles are aligned.
Secure the two axle spindles to the axle tube using two
M6x45mm bolts (25) and M6 locknuts (19). SEE FIGURE 4

Owner's Manual
TX158 ATV Trailer
Check for parts online at www.yutrax.com or call 800-345-6007 M-F 8-5 CSTPage 4
8. Slide the two wheels (13) onto the axle spindles (6) with
grease fittings and air valves facing outward. Secure with
two 20mm castle nuts (17) and 20mm steel washers (14).
Tighten the castle nut until snug and then back off slightly
to allow free movement of the wheels and cotter pin (27)
alignment. SEE FIGURE 5
9. Insert the two cotter pins (27) through the axle spindles
(6) and castle nuts (17) so that the head of each cotter pin
is seated in the corresponding castle nut. Using a pair of
pliers, bend the prongs of the two cotter pins around the
other side of the castle nuts so that the cotter pin cannot
fall out. SEE FIGURE 5
10. You must now tighten all nut and bolt assemblies.
Be sure not to over tighten or crush tubing when
tightening.
11. Grease both wheels with a grease gun and high quality
bearing grease. Check the grease level frequently to
prevent bearings from excessive wear or failure.
12. Slide the removable tailgate (3) into the channels on
the rear trailer frame (2). Slide the four side containment
racks (8) and the one front containment rack (9) into the
corresponding tubes on the trailer frame assembly.
SEE FIGURE 5
NOTE: Make sure the tire pressure does not exceed the
maximum rating written on the tire. Recommended
operating pressure is 7 psi.
OPTIONAL ACCESSORIES
TX113 2" Ball Hitch Kit
TX191 Tracking Beam Kit
FIGURE 5
13
6
17
14
27
3
2
8
9

Check for parts online at www.yutrax.com or call 800-345-6007 M-F 8-5 CST Page 5
Owner's Manual
TX158 ATV Trailer
Always…
• Be sure the trailer is securely attached to ATV hitch.
• Check tires for correct air pressure before each use.
• Use as four-wheeled ATV trailer only.
• Inspect before each & every use to be sure there is no product
damage or loose/missing bolts & hardware.
• Have wheel bearings properly greased to avoid bearings
from seizing.
WARRANTY
YUTRAX™, a division of Ardisam Incorporated, offers a one year limited warranty to be free from defects in materials and
workmanship for the service life of the product, not to exceed twelve consecutive months from the date of purchase.
This warranty applies to the original owner with a proof of purchase and is not transferable. This warranty applies only
to products which have not been subjected to negligent use, misuse, alteration, accident or if repairs have been made
by anyone outside our factory. This warranty supersedes all other warranties either expressed or implied and all other
obligations or liabilities on our part. Ardisam, Inc., does not assume, and does not authorize any other person to assume for
us, any liability in connection with the sale of our products. Warranty work must be sent directly to Ardisam, Inc., or one of
our authorized service centers and performed by them. To obtain warranty service and/or replacement instructions, you must
have prior approval from Ardisam, Inc., before shipping your package to us by calling our customer service department at 800-
345-6007 between 8 a.m. and 5 p.m. Monday through Friday, or by writing to: Ardisam, Inc., P.O. Box 666, 1160 Eighth Avenue,
Cumberland, WI 54829 for a return material authorization number (RMA#). All items must be shipped prepaid. Ardisam, Inc.,
will at no charge, repair or replace, at their discretion, any defective part which falls under the conditions stated above.
Ardisam retains the right to change models, specifications and price without notice.
For replacement parts, phone [phone] or go online to www.yutrax.com.
Never…
• Use excessive speeds while towing trailer.
• Exceed the maximum load capacity of 1250 Ib.
• Allow people or animals to ride in trailer.
• Use on hilly terrain.
• Use a damaged product.
• Use when intoxicated or using over-the-counter medication
or prescription drugs.
• Use on rocky or obstacle ridden terrain.
• Use carelessly -- Think Safety!

Owner's Manual
TX158 ATV Trailer
Check for parts online at www.yutrax.com or call 800-345-6007 M-F 8-5 CSTPage 6
TX158 ATV Trailer assembled
PARTS BREAKDOWN
9
- MESH REMOVED
FOR CLARITY
8
1
27
14
13
6
19
25
21 5
7
10
11
15
18
12
20
22
17
3
2
- MESH REMOVED
FOR CLARITY
MESH REMOVED FOR CLARITY -
23
24
16
424
26

Check for parts online at www.yutrax.com or call 800-345-6007 M-F 8-5 CST Page 7
Owner's Manual
TX158 ATV Trailer
KEY # PART # DESCRIPTION QT Y.
1 300713 FRONT TRAILER FRAME 1
2 300710 REAR TRAILER FRAME 1
3 300704 TAILGATE 1
4 300705 AXLE MOUNT PLATE 2
5TK80M AXLE TUBE 1
6TK48M AXLE SPINDLE 2
7 TK81 REAR TONGUE TUBE 1
8 300700 SIDE CONTAINMENT RACK 4
9 300701 FRONT CONTAINMENT RACK 1
10 13098 LATCH TUBE ASSEMBLY 1
11 TK89 CONNECTOR POCKET 1
12 TK85 FRONT TONGUE TUBE 1
13 TK78 TRAILER WHEEL 2
14 22352 WASHER M20 2
15 22340 WASHER M8 7
16 11498 WASHER M6 16
17 22363 CASTLE NUT M20 X 1.5 2
18 22339 NUT M8 X 1.25 5
19 11499 NUT M6 X 1.0 14
20 22338 BOLT M8 X 1.25 X 100 2
21 22337 BOLT M8 X 1.25 X 70 1
22 22336 BOLT M8 X 1.25 X 60 2
23 22335 BOLT M6 X 1.0 X 65 2
24 22334 BOLT M6 X 1.0 X 50 6
25 22332 BOLT M6 X 1.0 X 45 2
26 22331 BOLT M6 X 1.0 X 40 4
27 4155 COTTER PIN 2
PARTS LIST

YUTRAX™, Division of Ardisam, Inc.
1160 8th Avenue, PO Box 666
Cumberland, WI 54829
800-345-6007 | Fax [phone]
E-mail: [email protected]om
Check for parts online at www.yutrax.com or call 800-345-6007 M-F 8-5 CST