Place your Instant Gazebo
frame in the center of area
to be shaded. With partner,
grasp two outer legs, slightly
lift off the ground, and step
backwards, stopping at full
arms’ length.
INITIAL SET UP
SET UP
PACKAGE INCLUDES
With partner on opposite side
of canopy, grasp the top and
bottom of the truss on
opposite sides. Lift up and
step backward until canopy is
3/4 opened. Be careful not to
pinch fingers. Expand frame
to fully open. Make sure the
vent fingers are released –
over the LARGE FABRIC.
1
Attach the larger fabric
to the frame by
inserting the 2 clips
into the small holes at
the top of each leg.
4
Spread the top vent fabric
(A) over the peak section
and slide the 4 fabric corners
over the 4 vent fingers.
2
To engage Pull Pin slider at each
corner, first lift the fabric off of the
slider, then with one hand hold
the top of the leg while pushing
up on the slider with the other
hand. The Pull Pin will engage the
hole. Repeat on all 4 corners.
2
Expand the frame to approx.
2/3 open. Spread the larger
fabric (B) over the frame,
tuck the fabric under the top
vent fabric fingers and using
the hook and loop strips,
secure the top to the trusses
at 8 different points.
3
• Instant Gazebo Frame
• Two-Tone Polyester Top (A)(B)
• (4) Corner Skirts (C)
• Roller Bag
• 4-Piece Stake Kit
Please read each step before you attempt to set up. Save these instructions for future reference.
1
a) Insert extension rods in the top of the legs. b) Secure corner fabric to the leg by inserting the
2 clips into the small holes at the top of each leg. c) Finally, pull the fabric out over the end of the
extension rods and secure using the sewn pockets. Repeat on all 4 corners.
3
Lift outer legs up and slide out
the inner legs until the snap
button locks into the outer leg.
Repeat on opposite legs.
4
TAKE DOWN
1) Erect frame to the lowest setting.
2) Wrap the skirt around the outside of
the leg with the clip on top.
Non-coated side facing outward.
3) Connect the elastic clips around
the top truss on both sides.
4) Use the attached tie-back straps to
gather the skirt.
Repeat on all 4 corner skirts.
5(C) ATTACHING CORNER SKIRTS
With partner, slightly lift up 2
adjacent outer legs, depress snap
button to unlock and telescope
inner legs into outer legs.
Repeat on opposite legs.
1
Now, with the canopy in
lowered position, remove
extension rods.
1) Pull the fabric back out
from the sewn pockets to gain
access to extension rods.
2) Remove fabric by releasing
the 2 clips from the small
holes at the top of each leg.
3) Carefully slide extension
rods out from the top of the
legs. Repeat on all 4 corners.
2
Release Pull Pin at each corner
by first lifting fabric away from
slider. With one hand push up
on truss near the Pull Pin,
pull the pin out to release.
NOTE: It is much easier to
release Pull Pin when the
canopy weight has been
removed from the Pull Pin.
3
With partner on opposite
side, grasp top and bottom
area of trusses.
Lift the
canopy up slightly and shake
it while stepping towards
your partner until the unit is
3/4 closed. With each
partner grasping two outer
legs, push frame together to
fully close it. Be careful not to
pinch fingers!
Store canopy in roller bag.
4
Clips
Elastic
Clips
Pull
Pin
Snap
Button
Snap
Button
a
a
b
b
c
c
(A) (B)
WARNING: Keep all flame and heat sources away from all product fabrics. These fabrics meet
the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact
with any flame source. The application of any foreign substance to the fabric may render the
flame-resistant properties ineffective.
