ZAERO DESIGN EVO-1 FRONT LIP User manual

EVO-1 FRONT LIP
FOR VW GOLF MK 7.5 GTI
Installation Manual
WWW.ZAERO-DESIGN.COM

EVO-1 FRONT LIP
FOR VW GOLF MK 7.5 GTI
TEST FITTING
Please note we recommend to disassemble the
original front bumper for installing the splitter.
Align the new front lip with the original bumper
so that the ends align with the original parts.
REMOVING PROTECTIVE FILM OF THE
SPLITTER
1- Clean the original front bumper with a
suitable degreaser. Now remove the
protective film from the front lip.
APPLYING THE SPLITTER TO THE BUMPER
1- Use the bolts for the pre drilled holes
marked RED! Secure the bolts by adding the
nuts. Please make sure to use washers on
both sides.
2- You can now reasamble the undertray.
We wish you a lot of fun with your new front lip!
Tuning is not just a passion, it’s a lifestyle!
Enjoy it!
PRE DRILLING THE HOLES
With the splitter in the correct position, drill
the holes through the original front bumper
marked on the drilling template in RED! with
a 7mm drill bit.
HOLES NEED TO BE DRILLED
1
2
3
1
Washer
Washer
Nut
Bumper
layer
Splitter
layer
Screw
7mm Driller
4
BOLTS + NUTS + WASHER SELF TAPPING SCREWS