ZAERO DESIGN EVO-1 User manual

EVO-1 DIFFUSER
FOR VW GOLF MK 7.5 R
Installation Manual
WWW.ZAERO-DESIGN.COM
You can now t the spacer sleeves between the diffuser and the steal holders. Put the
long threaded screw through the holes in the middle of the diffuser and the sleeve and
screw it into the threaded sleeve.
Inserting the plastic threads into the original steel holders.
After the centre section of the diffuser has been attached, you can now attach the
diffuser extensions on the left and right. Screw both extensions below the bumper to
the original bumper and diffuser.
Done! We wish you a lot of fun with your new diffuser!
Tuning is not just a passion, it’s a lifestyle!
Enjoy it!

CONNECTING BUMPER, DIFFUSER AND EXTENSION
CONNECTING BUMPER AND EXTENSIONS
THREADED SLEEVES
EVO-1 DIFFUSER
FOR VW GOLF MK 7.5 R
DISASSEMBLEY OF THE ORIGINAL DIFFUSER
Please remove the original Diffuser. The
easiest way to release the anchoring clips
from the bumper is to press them down on
the inside of the bumper, so that the clip
does not lock. Please note the fastening
points below the bumper.
REMOVING PROTECTIVE FILM
Please peel off the protective lm slightly at the edges so that you can remove
the protective lm more easily when mounted.
ATTACHING THE DIFFUSER EXTENSION (LEFT + RIGHT)
1
2
4
original Bumper
original Bumper
Anchored correctly
Not anchored correctly
Diffuser
Diffuser
Clip
Clip
INSTALLATION OF THE DIFFUSER
You can attach our diffuser now. Make sure that all tabs are inserted
correctly in the original bumper.
Gently push the diffuser onto the bumper to achieve the correct position.
As the bumpers are often very soft in the middle and give way, make sure that
you can hold against them from the inside if necessary.
The clips must now anchor with the bumper.
3
OEM Bumper
Diffuser