ZANE ARTS LT-201 User manual

LT-201 / OZ HANGER
MANUAL - Ver 1.01
EN

■ CONTENTS / PART NAMES
Main Unit
2
Section A
Section B
Section C
End Cap
Driving Rod
Hook
Holder
Storage
Case
Hole for
Removal
Gauge
Please be sure to read the manual before using this product.
If you have any questions or if there is a problem with the
product, please contact the store where you purchased the
product or us directly.

Maximum Load 3kg
3
The maximum load capacity is 3kg. For fuel-burning lanterns,
such as gas or kerosene, the lantern should weigh 3 kg or less
with fuel.
3kg
Hanging more than
3kg may damage
the product or
cause it to tip over.
■ABOUT THIS PRODUCT
Please take some time to understand the characteristics of
this product before using it.

●High risk of fire. Never use gas, gasoline, or kerosene
lanterns under or near flammable objects such as tents,
shelters, tarps, and trees.
●When using this product with gas lanterns, please take extra
precaution not to move the hanger. The gas lantern may
become damaged by moving, causing fuel to leak and the
risk of fire.
●The end of the rod is sharp. Never point it towards another
person.
4
■ HANDLING PRECAUTIONS
Be sure to read and understand the following contents
before use to prevent harm to the user and others, and
damage to property.
INDICATES CONTENT THAT MAY RESULT
IN DEATH OR SERIOUS INJURY.
!
!
DANGER

●The maximum load capacity is 3kg. Be sure your gas or
kerosene lantern weighs 3kg or less with fuel.
●Do not use this product in places where the ground is too
loose or too hard to properly secure the driving rod.
●Do not use in rainy or high wind conditions. The hanger
may fall over in windy conditions or if the ground is loose due
to heavy rainfall.
●Please install this product upright. A lantern is more likely to
fall when the hanger is crooked.
●Before hanging a lantern, please make sure the button lock in
each section is secure and the holder’s lock screw is tight.
●Remove the lantern when sleeping or when away.
●Please remove your lantern from the hanger before pumping,
refueling, or replacing a cartridge.
●Inspect the connecting parts after each use. If any
abnormality is found in the product immediately stop using.
5

6
●This product is for temporary outdoor use only. Do not install
permanently or use in undesignated ways.
●After attaching the main unit to the driving rod, never attempt
to correct the angle of the driving rod by leveraging the
hanger. This may damage the hanger.
●After each use, wipe off any moisture and dry thoroughly
before storing. If stored wet or uncleaned the product may
corrode.
●Salt accelerates corrosion. When used near the ocean
always wash with fresh water and dry thoroughly before
storing.
●When storing the driving rod, always cover the pointed end
with its end cap.
●Please keep out of reach of infants and children.
●Do not modify this product, it may impair its performance.
INDICATES CONTENT THAT MAY CAUSE
INJURIES OR PROPERTY DAMAGE.
WARNING
!

■ SETUP PROCEDURES
7
MAIN UNIT ASSEMBLY
1
Button Lock
Securely
locked
Lock sections A, B and C with button locks.
The hanger can also be used at a lower height
by removing section B.
Section CSection BSection A

8
DRIVE RODE INTO GROUND
2
Use a hammer to vertically drive the rod into the ground.
Using the gauge line, drive the rod up to the 30 cm gauge line.
If the ground is too hard to reach 30 cm, 20 cm to as a guide.
After driving, make sure that the driving rod is secure.
Gauge : 30cm
Ground
Gauge : 20cm
Hammer
Pound
Vertical Driving Rod

9
ATTACHING THE HANGER
TO THE DRIVING ROD
3
Attach hanger to driving rod by sliding
into place, tighten lock screw.
※After attaching the main unit to the driving rod,
never attempt to correct the angle of the driving rod
by leveraging the hanger. This may damage the hanger.
Ground
Main
Unit
Lock
Insert the driving rod
firmly into the holder
and screw in firmly. Driving
Rod
Holder

10
HANG A LANTERN
4
Hang a lantern on the hook
The maximum load capacity is 3kg (for fuel-burning lanterns,
such as gas or kerosene, the lantern should weigh 3kg or less with fuel).
Always remove lanterns from the hanger
in high winds, when sleeping,
and when away.
Lantern

11
If the driving rod is difficult to remove, insert a peg or other object into
the hole in the driving rod, rotate back and forth and pull to remove.
Ground
Peg or other object
■ REMOVAL

12
■WARRANTY AND REPAIR
If you find any defects in the product, please contact the store where you
purchased it or us directly. We will replace or repair any item found to have
a manufacturing defect free of charge. We will repair products with damage
caused by wear and aging at a reasonable price. Please note that it may be
difficult to obtain some materials due to the discontinuation of products and
parts, and repairs may not be possible based on the condition of the
product.
※When sending a product for repair, please remove dirt and moisture from
the product before sending it. Moisture and dirt may interfere with repairs.
Items that are not clean and dry upon arrival for repair will incur additional
charges at their own expense for cleaning. Thank you for your
understanding.
Zain Arts Co., Ltd.
7190-2 Shimauchi, Matsumoto, Nagano 390-0851
Phone: [phone] FAX: [phone]
[email protected]