Zartek ZA-457 User manual

Rechargeable LED Extreme Bright Flashlight
ZA-457
USERS MANUAL
Thank you for purchasing this Zartek f ash ight. This f ash ight has been
engineered and manufactured to give you years of dependab e operation. P ease
take a few moments to read through the manua to get fu usage from this
innovative product.
SPECIFICATIONS:
• Extreme Bright LED CREE L2 lobe, 600 Lumen beam
• Extra Heavy-duty Aluminium Casing with belt clip
• Magnifying Lens for Uniform Light
• Focus Beam Flood to Spot
• Shockproof & Rainproof IP65
• 3 Modes of Operation: High Beam, Medium Beam, Strobe
• Tactical Back Durable Button
• Rechargeable via Mains/Vehicle
• Li-ion Rechargeable Battery 18650
• Charging time: 3 hours
• Direct Plug-in Charging with Indicator (4.2V)
PRESS BUTTON TO BE IN CHAR IN
• Over 500 Recharge Cycles per Battery
• Dimensions: Length 150mm, Head diameter 40mm, Shaft diameter 24mm
• Weight including Battery: 200g
HI H BRI HT BEAM
Avoid direct eye exposure or serious eye injury cou d resu t.
To prevent damage to eyesight, never ook into ight when it is on.
Do not shine in any face.
This item is not a toy. Keep out of reach of chi dren
Charging:
The Zartek ZA-457 f ash ight is portab e and rechargeab e yet extreme y bright
with a ong operating time. Direct y p ug in the mains or vehic e adaptor into the
side socket to charge. To ocate the charging socket, extend the f ash ights head

and ift the rubber socket. On y recharge using supp ied adaptors with output of
4.2V.
A red LED on the adaptor indicates charging,
green LED indicates fully charged.
Charging will only begin if the torch button is in
an ON mode.
P ug the charger into the side charging socket
when the torch is OFF. Press the button at the back
of the torch to start recharging.
Recharging is easy and safe as the battery cannot be overcharged. The charger
wi stop charging once fu .
• Charging time 3 hours
• Direct plug-in charging with indicator
• Li-ion rechargeable battery
• Over 500 recharge cycles possible
This f ash ight has a Li-ion battery pack. To protect the battery from discharge
during shipping, a round p astic insu ator fi m is inserted inside the battery
compartment between the battery and the torches back switch contact.
Remember to remove the insu ator piece before first time use.
A though the unit arrives partia y charged from the factory, it must be fu y
charged for 3 hours before first use. This initia charge pre-conditions the battery
for fu capacity. Fai ure to charge may shorten the ife span of the battery. Once
the ight gets dim, recharge the battery immediate y as it cou d get damaged if
eft very f at.
A ways make sure to rep ace the rubber p ug covering the socket after charging
to keep the f ash ight sp ash proof.

WARNIN !
• Fu y charge the f ash ight before storing for ong periods. Keep recharging
every few months or the battery may go fau ty.
• Do not recharge this f ash ight with any other adaptors other than those
supp ied with the unit.
• Do not dispose of the battery in a fire or ordinary waste.
• Do not operate the f ash ight in high temperature, hazardous or exp osive
environments.
• Do not subject the f ash ight to strong impacts.
• Do not disassemb e or modify the f ash ight as it contains protective
devices which, if damaged, may cause the battery to heat or ignite.
• Do not eave the f ash ight in direct sun ight or hot spaces for extended
periods.
• Never short circuit, reverse po arity, disassemb e, damage or heat the
battery packs over 100°C. If an exp oded Li-ion battery does ignite, it wi
burn more vio ent y if it comes into contact with water or moisture. Never
put water on a burning Li-ion battery on y use a fire extinguisher.
• This f ash ight is rain and sp ash proof on y but not submersib e. If the ight
gets submersed in water, immediate y dry the f ash ight and do not use for
a few days. Water damage is usua y irreparab e.
Operation:
Press the back tactica switch mu tip e times to
togg e between ighting modes.
3 Modes of Operation: High Beam (2.5 hrs), Medium
Beam (5 hrs), Strobe (6 hrs)
Beam distance: 250 meters
Memory function enab es the torch to turn on in the ast mode used. The mode
will only be memorised if the torch is ON for more than 5 seconds. If the
torch is ON for ess than 5 seconds the mode wi be changed. To change quick y
between modes, soft press the back tactica switch.
A unique focussing head design a ows the beam shape to be changed quick y.
Extend the ight head outwards to focus the beam into a concentrated beam for
further reach. Pu in the head for a wider shorter beam. A curved magnifying
ens distributes ight uniform y.

The Zartek ZA-457 f ash ight has a s im design and arge durab e tactica switch
which are essentia for security, tactica and firearm technique app ications. This
powerfu torch is a so durab e and idea for outdoor, mining, industria and
genera use. LED g obes are shockproof and never need rep acing. The
a uminium casing is shockproof & sp ash proof (IP65).
Maintenance:
A batteries ose charge over time. It is recommended that the f ash ight shou d
be fu y recharged every 2-3 months when not in use.
If the unit gets dirty, gent y c ean the outer surface of the f ash ight with a soft
c oth moistened with a mi d so ution of water and detergent.
Store in a coo , dry p ace.
Warranty:
This product is warranted by Zartek against manufacturing defects in materia s
and workmanship under norma use for a 12 month period from date of purchase
via our authorized appointed dea ers.
For further information or any queries, please email us: [e-mail]