Zennio GetFace IP ZVP-FFRA2 User manual

GetFace IP
Flush installation - Frame - 2 modules
ZVP-FFRA2 Assembly instructions
© Zennio Avance y Tecnología S.L. Ed. 1 For more info www.zennio.com Page 1/ 2
Note: This product must be purchased together with the frame ZVP-FBOX2
ASSEMBLY OF FRAME (ONE-COLUMN LAYOUT)
1 Please remove the basic unit blind panel and place the
auxiliary parts supplied with the frame.
2 Place the basic unit inside the flush-mount box and recover
the cables. Fix the enclosure with the screws (included).
3 Connect the cables to the basic unit and interconnect the
additional modules with the bus.
4 . Fix the blind panel (or additional modules that remain in
sight) with the supplied screws and put the labels with captions
next to the buttons.
5 Place the frame. 6 Fix the frame by using the supplied Allen key.

© Zennio Avance y Tecnología S.L. Ed. 1 For more info www.zennio.com Page 2/ 2
ASSEMBLY OF FRAME (MULTIPLE-COLUMN LAYOUT)
1 Please remove the blind panels and the additional modules
from the enclosures. After that, assemble the additional module
enclosures, opening the gaps previously. Then, fix the assembly
using the supplied parts and screws (included).
2 Place the metallic parts supplied with the frame. Put the
assemblies inside the flush-mount box, pass previously the bus
through the gaps and recover the cables.
3 Fix the assemblies to the flush-mount boxes with screws. 4 Make the connections of the basic unit and prepare the
additional modules. Pass the bus cables through the gaps.
5 Interconnect the additional modules with the bus as
indicated in the schema and then, fix the additional modules
with the supplied screws.
6 Place the frames and fix them by using the supplied Allen
key.