Please take a few moments to check all pack contents listed.
Assembly requires 2 persons.
Tools required: 10mm Spanner, Corded/Cordless Drill, Pozi-drive
Bit/Screwdriver, Tape Measure, 3mm Drill Bit required in order for you to drill all
screw holes before construction.
21
1. Position Leg Assembly B1 onto Armrest A ensuring correct orientation of
components (Fig.1). Attach using 2no 70mm Coach Screws & Washers. Repeat
procedure for remaining Leg Assembly B2 and Armrest A.
2. Place Seat Assembly C onto LegAssembly B1 and attach using 2no 70mm
Coach Screws & Washers (Fig.2). Repeat procedure to attach LegAssembly B2.
3. Place partly assembled seat in upright position and attach BackAssembly D to
Seat Assembly C using 2no 70mm Coach Screws & Washers (Fig.3a).
Attach Back Assembly D to Armrests A using 2no 90mm Coach Screws –1no
per Armrest (Fig.3b)
4. Position Fascia E as shown in Fig.4 and attach using 2no 50mm Screws.
5. Invert chair assembly and place on a flat surface. Position 2no Diagonal Bracings
to rear of chair and fix into position using 4no 50mm Screws (Fig.5a).
Position and fix remaining 2no Diagonal Bracings as shown in Fig.5b & 5c using
4no 50mm Screws. Repeat stages 1-5 for second seat.
6. Attach TableAssembly F to legs of completed seat using 2no 60mm Screws
(Fig.6). Similarly attach Table Assembly F to remaining seat.
www.zest4leisure.co.uk
