ZIPPY TSPD-01 User manual

PLACE DISPENSER ON BOX
WITH HANDLE PARALLEL TO
SURFACE & PRESS
WHILE PRESSING, ROLL TAPE
ONTO BOX
KEEP ON ROLLING
- - PLEASE SEE OTHER SIDE - -
PRESS TAPE FIRMLY TO BOX
(MAKE SURE IT STICKS WELL)
LIFT GENTLY TO CUT
TURN RUBBER ROLLER TO
ADVANCE AROUND 1/2”OF
TAPE ONTO FINGERS
PULL OUT MORE TAPE
AND PLACE ONTO BOX
PRESS DOWN AS YOU
ROLL TAPE ONTO BOX
1
HOLD TAPE IN PLACE WHILE HOLDING TAPE TO BOX,
LIFT DISPENSER UP GENTLY
TO CUT
TWO HANDED
ONE HANDED
OR
TSPD-01
3
3
45
2
145 2
USE ‘ONE HANDED’ OR ‘TWO HANDED’ OR ANY COMBINATION *
*PLEASE NOTE: After using Zippy the ‘two handed’
way for a while, you’ll probably use it ‘one-handed’
most of the time.
There are many variables while taping; the particular
tape and box you’re using, size of the box, your
position relative to the box, box or other item such as
envelope, personal preference, etc. - so, you’ll probably
enjoy the fact that Zippy was designed to be used in
many possible ways to suit your needs.
Dust: Keep your rubber roller free of dust by following
instructions (see other side) to clean periodicaly. If
using with dusty boxes, you can prevent dust from
reaching roller by starting with #1, top left - turn
rubber roller... before continuing either‘one’ or ‘two
handed’.
CONTINUED

- - PLEASE SEE OTHER SIDE - -
TAKE A PIECE OF TAPE A FEW
INCHES LONG
PLACE & REMOVE THE STICKY SIDE
OF THE TAPE ONTO THE SURFACE
OF THE RUBBER ROLLER
DUST WILL TRANSFER FROM THE
RUBBER ROLLER TO THE TAPE
PUSH TAPE ROLL ONTO TAPE
HOLDER AS FAR AS IT WILL GO
STICKY SIDE FACING HANDLE
PLASTIC MARK INDICATES
TAPE FEED PATH
1
PULL OUT A FEW INCHES OF
TAPE & PLACE WHERE
INDICATED. HOLD ZIPPY AS IN
PICTURE WHILE TURNING
RUBBER ROLLER TO FEED.
TSPD-01
1
1
3
2
2
2
1 2
LOAD NEW TAPE ROLL FEED TAPE
RUBBER ROLLER MAINTANENCE - - TO REGAIN ITS TACKY SURFACE
ANOTHER WAY TO CUT
VIDEO INSTRUCTIONS
at tapestar.com
STICKY SIDE