1
Quick Installation Guide
Package Contents
˙
One 56K/V.92 FAX MODEM
˙
One Quick Installation Guide
˙
One J-11 cable
˙
One Installation CD
System Requirements
˙
P
Ⅱ
with 200 MHz CPU or better
˙
Operating System : Windows 98SE/ME/2000/XP/Vista
˙
32MB AM
˙
2MB or more hard disk space
Hardware Installation
a. Make sure that your PC is powered off. Unplug the power cord from the wall socket. Also turn
off all other peripherals you may have attached to your PC.
b. Open your PC case and locate an available PCI on the motherboard.
c. Slide the modem into the PCI slot. Make sure that all of its pins are touching the slot’s contacts.
You may have to apply a bit of pressure to slide the modem all the way in. after the modem
is firmly in place, secure its fastening tab to your PC’s chassis with a mounting screw. Then
close your PC.
d. Plug one end of the phone cable into the Line jack on your fax modem. The other end of the
phone cable should be connected directly to the phone outlet.
e. Power on your PC
Software Installation
For Windows Vista
a. The operating system will install all necessary driver files when modem installed. After
approximately 1 minute, a message will appear at the lower right-hand corner “Your new
hardware is now installed and can be used.” The hardware and software installation is
completed.
For Windows 98SE/ME/2000/XP
a. Insert the Installation CD into the CD- OM drive and select the path: Modem Card/
Motorola/Windows_SM56_6.12.05_DFV/ssetup.exe to install the driver you need. This will
install all necessary files from the Installation CD.
b. The installation will be completed after clicking Finish button.
12-086-00594 ev:02
