ZSK T8 Parts list manual

MESSAGES
Did you know this T8 function yet?
VOL. 006

2 | DID YOU KNOW? -MESSAGES
Did youknow?
What?
In the T8, it is possible to set messages, for
example, about an upcoming maintenance
interval. Conditions for triggering the message can
be dened via parameters. In addition, it can be
dened whether it is only a message or whether
this even triggers a machine stop.
Why?
The purpose of this message is to prevent
maintenance intervals from being forgotten, which
could result in long-term damage to the machine
(e.g. due to insucient lubrication).



Did youknow?
Step1
On the main screen press the L3 function key to
enter the „Service“ tab. Press L3 again to enter
the „Message“ tab.
Step2
Use the L1-L5 function key to activate a
message.
Pressing the corresponding R1-R5 function key
leads to the message settings.
Step3
Use the L1-L8, R1-R8 and U1-U0 function key to
enter the message text. Conrm with OK.
3 | DID YOU KNOW? -MESSAGES


Did youknow?
Step4
In the settings dene the message triggers and
whether a machine stop should be initiated.
Press L8 to conrm.
4 | DID YOU KNOW? -MESSAGES

ZSK Stickmaschinen GmbH
Magdeburger Str. 38-40
47800 Krefeld, Germany
Fon: [phone]
Fax: [phone]
E-Mail: [e-mail]