Zycoo ZX20 SERIES User manual

WWW ZYCOO COM..
QuickStart Guide
Inbound Route Configuration
When a call from outside you want to
forward this call to an extension or IVR
here you will be introduced how to deal
with the inbound calls ClickInbound
Routes to show the diagram at right
,
,
,
.【
】.
●
(/)
,
,.
.
General
When a call from a trunk Analog VoIP , it
should be forwarded to an extension call
queue conference or IVR You can choose
flexibly based on your requirement
●
() ,
,,
.
●
,
,,
.
Analog Chanel DID
If you want to direct the inbound call from
a trunk Analog to a specified extension
call queue conference or IVR you can
use this function
VoIP Channel DID
If you want to direct the inbound call from
a VoIP trunk to a specified extension call
queue conference or IVR you can use
this function
Network and Tone Zone
Configure IP address of WAN port of IP
PBX and choose relevant tone for
different zone
Click to show the
diagram at right
,
.
【】
.
Network And Country
ZX20
IP PHONE SYSTEM
POWER SYS WAN USB PORT1 PORT2
ZX20
Small and Medium Business
IP Phone System
Outbound Routes is to define what trunk is
used for outbound call by extension user
If you don t allow extension user call out
pls ignore this part
.
',
.
Click Basic Outbound Routes to set
In this page you can configure basic
match pattern of outbound routes and
create different dial plan
Click Add a Dial Rule to show the
diagram at right
【】->【 】 .
,
.
【】
.
Outbound Routes

LED
Mark Function Status Description
Power status
System Status
WAN Interface Status
On
Off
On
Off
Wink
Off
Green
Red
Off
Power On
Power Off
System Working
System Failed
Data Exchanging
No Data Exchanging
FXS Channel
FXO Channel
Failed
PWR
SYS
WAN
Getting IP Address
ZX20 ://
:
: ://...:
IP PBX support 3 ways to get the IP Address Static DHCP PPPoE
Default IP and Port of WAN
WAN Port IP http 192 168 1 100 9999
Login IP PBXZX20
After connecting IP PBX to your
local network open a web in your
PC and input IP address of IP
PBX then login page is shown at
right Default username and
password are admin
,
,
,
.(
)
ZX20
ZX20
PORT1~PORT2
Common Button
Besides of the device info in the home page the following common
buttons are displayed as well
,
:
Log out Log out GUI
Reboot Reboot the IP PBX system
Factory Defaults Restore all settings to factory default.
Configure Extensions
ZYCOO IP PBX support SIP IAX2
and analog extension configure
extension from this page
Basic Extensions
Extension Settings
Define extension number dialplan or
define a FXS analog phone for this
extension
Advanced Options
Open Close SIP IAX registration set
Agent set IP Permit to define a IP
address to register IP extension
Codecs Configure
/
,
:
【】->【 】
●s
,,
.
●
// ,
,
.
●
Add Trunk
If you want to set up outbound call
by connected to PSTN Public Switch
Telephone Network or VoIP provider
pls configure on this page
Basic Trunks
(
),
:
【】->【 】
:,,.
ZX20 IP PBX support three kinds of
trunks Analog VoIP Peer
Analog Module Status
Analog Phone Router
Power Adapter
PSTN
FXO Connect PSTN
FXS Connect Analog Phone
PORT1 PORT2 WAN PWR RST
Assembling the ZX20