Zycoo ZX50-A4 User manual
2. Hardware Installation
The followings are instructions for setting up ZYCOO ZX50.Refer to the
illustration and follow the simple steps below to quickly install your IP
phone system.
1-4/8 are LED marks of ZX50-A4/A8
G1-G4 are LED marks of ZX50-AG42/G4
TE1-TE4 are LED marks of ZX50-B4
ALARM、LINK are LED marks of ZX50-AE41
Power tatus
System Status
WAN Interface Status
S
On
Off
On
Off
Power On
Power Off
System Working
System Failed
Data Exchanging
No Data Exchanging
Data Exchanging
No Data Exchanging
PWR
SYS
WAN
LAN
1-4/8
LAN Interface Status
Analog Modules Status
GSM Modules Status
BRI Status
E1 Status
E1 Status
Wink
Off
Wink
Off
Green
Red
Off
On
Off
On
Off
GSM Channel
Failed
BRI Connected
Calling
E1 Connected
E1 Not Connected
E1 Not Connected
E1 Connected
FXS Channel
FXO Channel
Failed
Green
Off
Red
Green
G1-G4
TE1-TE4
ALARM
LINK
Mark Function Status Description
2. 1 LED Definitions
FXO port is connected to PSTN
FXS port is connected to analog phone
E1 Port Connected to PRI
TE4 - TE1 Port Connected to BRI
SIM1 - SIM4 for SIM Card
After press the “Reset” button, all the system data will reset
to default, if possibility, back up the config file before reset.
Thank you for purchase ZYCOO products. The above steps introduce
simple configuration for ZX50. For further configuration, please refer
to the user manual. If you have other questions, please contact the
local dealer or distributor where you purchased this product.
You can also browse our online FAQ resource at the ZYCOO website at
first to check if it's helpful to solve your issue. If you need more support
information, please contact ZYCOO support team.
ZYCOO online FAQ :
http://www.zycoo.com/support
Support team mail address :
support@zycoo.com
Copyright © ZYCOO Co., Ltd. 2012.
This manual suits for next models
4
Table of contents
Other Zycoo Telephone manuals
