ZyXEL Communications WX3100-T0 User manual

Quick Start Guide
WX3100-T0
Dual-Band Wireless
AX1800 Gigabit Extender

1
2
3

Plug in the power adaptor to the WX3100 ,
and press the power button on the back of the
extender . The Power LED lights up steady
green. (Wait for about 2 mins).
Setting up the WX3100
Place the WX3100 where you want to extend
your wireless network.
2
1

Using the Ethernet cable, connect the WX3100
LAN port to the the MPro Mesh Router LAN
port. Check the Power and LINK LEDs are lit
green on the front. (This may take a few minutes)
Plug in the power adaptor . Make sure your
LINK LED is green (preferred) or amber.
Unplug the Ethernet cable from the WX3100 and
place the WX3100 where you want to extend
your wireless network.
Set up with MPro Mesh Router
3
2

Use another Ethernet cable and connect the LAN
port of the second WX3100 to the LAN port of the
first WX3100 . Wait until the POWER and LINK
LEDs on the second WX3100 are green.
Set up with non-MPro Mesh Router
and two WX3100s
Using the Ethernet cable, connect the LAN port of
the first WX3100 to the the non-MPro Mesh Router
LAN port . Check the Power and LINK LEDs are lit
green on the front. (This may take a few minutes)
Unplug the Ethernet and power cable from the
second WX3100 and place where you want to extend
your wireless network.
Plug in the power adapter . Make sure your LINK
LED is green (preferred) or amber.
3
3
2

Any question?
If you have any further questions setting up,
please visit https://zybre.co.uk
email [email protected]
or call us on 0330 320 2062