ZyXEL Communications C424G User manual

1/2 Copyright © 2016 ZyXEL Communications Corp. All Rights Reserved
EU Importer: ZyXEL Communication A/S, Generatorvej 8D, 2860 Søborg, Denmark. http://www.zyxel.dk
US Importer: ZyXEL Communications, Inc 1130 North Miller Street Anaheim, CA 92806-2001. http://www.us.zyxel.com
Internet Setup
IP Address: 192.168.1.1
Username: admin
Password: 1234
Hardware Connections
Connect the power.
WAN/GPON
GREEN
PON not connected. Disconnect power and
repeat hardware connection steps.
PON connected and registered.
4
Connect a computer using an Ethernet cable.
PON connected but not registered.
1
3
4
VoIP registration failed.
VoIP registration is complete.
VoIP1
VoIP setting is not properly configured. Go to
the Web Configurator and configure VoIP
settings.
OFF
GREEN
RED
Connect a phone.
2
Make sure the LEDs are on and check the
GPON and VoIP LEDs.
1
2
3
WAN/GPON
WAN/GPON
VoIP1
VoIP1
OFF
GREEN
(blinking)
Quick Start Guide
C424G
Dual-Band Wireless AC/N GPON HGU with 4-port GbE LAN

2/2
Copyright © 2016 ZyXEL Communications Corp. All Rights Reserved
See the User's Guide at www.zyxel.com for more information.
1
Wall Mounting
23
Wireless
WPS
No WPS
WPS
2
Minutes
(Within 2 Minutes)
SSID
Wireless key
12
(In 1 second...)
(5 seconds)
WiFi 2.4G
(>5 seconds)
1
Press the WPS button until the
WiFi 2.4G LED flashes in orange.
2Press the WPS button on the client.
1
The SSID and wireless key are on the device's
bottom sticker.
2Find the device with its SSID. Enter wireless
key to connect.
12
Advanced Setup > Layer2 Interface > GPON Interface
ORANGE

Federal Communications Commission (FCC) Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generate, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
RF exposure warning
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment must be installed and operated in accordance with provided
instructions and the antenna(s) used for this transmitter must be installed to provide a
separation distance of at least 20cm from all persons and must not be collocated or operating in
conjunction with any other antenna or transmitter.