ZyXEL Communications PMG5318-B20B User manual

1/2 Copyright © 2016 ZyXEL Communications Corp. All Rights Reserved
EU Importer: ZyXEL Communication A/S, Generatorvej 8D, 2860 Søborg, Denmark. http://www.zyxel.dk
US Importer: ZyXEL Communications, Inc 1130 North Miller Street Anaheim, CA 92806-2001. http://www.us.zyxel.com
Internet Setup
IP Address: 192.168.1.1
Username: admin
Password: 1234
Hardware Connections
2
Connect the power and press the power
button.
3
1
PON
GREEN
PON
ORANGE
PON
RED
PON not connected. Turn off, disconnect power,
and repeat hardware connection steps.
PON connected and registered.
4
Connect a computer using an Ethernet cable.
PON connected but not registered.
Connect the fiber optic cable from your service
provider's network to the PON port.
Warning! To avoid possible eye injury, do NOT
look into an operating fiber-optic module's
connector.
134
6
5
Point the antennas up.
VoIP registration failed.
VoIP registration is complete.
PHONE1
PHONE1
VoIP setting is not properly configured. Go to
the Web Configurator and configure VoIP
settings.
OFF
PHONE1
GREEN
RED
Connect a phone.
PHONE1
2
5
6
Make sure the LEDs are on and check the
PON and PHONE LEDs.
Quick Start Guide
PMG5318-B20B
Wireless N GPON HGU with 4-port GbE Switch

2/2
Copyright © 2016 ZyXEL Communications Corp. All Rights Reserved
See the User's Guide at www.zyxel.com for more information.
173.2mm
1
Wall Mounting
2 3
Wireless
WPS
No WPS
WPS
2
Minutes
(Within 2 Minutes)
SSID
Wireless key
12
(In 1 second...)
(5 seconds)
Wi-Fi 2.4G
(>5 seconds)
1
Press the WPS button until the WLAN
LED flashes in orange.
2Press the WPS button on the client.
1
The SSID and wireless key are on the device's
bottom sticker.
2
Find the device with its SSID. Enter wireless
key to connect.
12
Advanced Setup > Layer2 Interface > GPON Interface
ORANGE