1 BY ONE OUK00-0314 Operating and maintenance manual

Digital Indoor HDTV Aerial
Model OUK00-0314
Congratulations!You have just purchased the nest, technologically advanced,
easy-to-install HD digital aerial for indoor use. 1byone® products have been
rated“best sellers.”We hope your investment in this quality aerial will give you
and your family years of enjoyment. Thank you for your purchase and your
support. We invite you to visit our website at www.1byone.com for other
high-quality products.
Package Contents -
Aerial with 1.35-meter Coaxial Cable
Instructional Manual
AC/DC power adaptor 12V
www.1byone.com
Copyright ©2015 1byone Products, Inc. All rights reserved
Will the picture be better than cable?
All cable companies compress their HD signals. The result is a degraded signal that is usually inferior to
DVB-T broadcasts. Many factors determine whether your picture quality will be better in every instance.
However, your picture quality should greatly improve using your 1byone® DVB-T compatible digital aerial.
Can I connect the aerial to multiple televisions?
The aerial's signal should only be split between multipleTVs if the aerial comes with an included
amplier.
Troubleshooting
The aerial isn't receiving any signals.
1. Check to make sure you have correctly connected the aerial to your HDTV or third-party HD receiver.
See the Setup Guide under,“Connect the Aerial on the Back of Your TV”in this manual.
2. Re-Scan for Channels. See the Setup Guide under, "Scan theTV for Channels" in this manual.
3. Reposition the aerial in a dierent location. Facing the direction of the broadcast tower is usually
best. Signal strength will vary based on certain conditions. Distance from the tower, hills, buildings, and
even tall trees can impact reception. Always re-scan for channels after moving the aerial.
One channel is missing.
1. Something may be obstructing the signal. Move the aerial, then re-scan for channels.
2. Try turning the aerial 10 or 20 degrees in either direction to avoid reection. Then re-scan for channels.
The picture or sound freezes while I am watching a channel, or there are boxes in the picture.
1. This is often caused by a weak or intermittent signal. Try moving the aerial to a dierent location or
aiming it in the direction of the broadcast tower for that channel.
For Optimal Performance
Place your 1byone® aerial in the location with the strongest reception. The best location may be to place it
near a window facing the direction of the broadcast tower. A television signal can become weak or intermit-
tent by trying to pass through walls that are exceptionally thick or contain large amounts of metal. Your
1byone® aerial can usually pick up the stronger signals from certain direction. Experiment with dierent
rooms to nd the best location to mount your aerial. To check the exact distance from your residence to the
nearest tower, go to http://www.digitaluk.co.uk/ and type in your postal code. You will then have a
better idea of what you should expect in the way of reception. If there are multiple tower locations,
optimize the position of your aerial by pointing it in the direction of the weakest signal (usually the farthest
away from you).
Distributed by
1byone® Products, Inc.
2313 E Philadelphia St, Ontario, CA 91761
www.1byone.com
®
尺寸：237X216mm 材质：铜板纸120g
正面背面
形式：折页

2. Mount the Aerial
Find a convenient indoor location to mount your aerial, then set up the channels using the following
"Scan the TV for Channels" steps below.
Note: Test your aerial location after scanning for channels. In some instances, you may decide to
relocate the aerial for better reception. See “Aerial Placement Options and Tips”below.
3. Scan the TV for Channels
A. In the TV’s setup menu, set the mode to Aerial or Air. Refer to the TV manual for detailed
instructions.
B. While in the TV’s setup menu, set TV to scan for channels.This can sometimes be listed as
auto-program, channel search or channel scan. Consult your TV manual for detailed instructions.
Aerial Placement Options and Tips
TV reception and quality depends on the distance from the transmitting tower to your home.
Surrounding environments may also aect signal strength and reception.
If your reception is sporadic or needs to be improved, try the helpful tips below:
1. Placing the aerial in a higher location may result in better reception.
2. Facing the aerial towards the broadcast tower may result in better reception.
3. Placing the aerial close to a window may also result in better reception.
Important:
Always re-scan for channels whenever you move your aerial.
Frequently Asked Questions
How many channels can I receive?
The number of channels you can receive will be determined by what is being broadcast in your area.
Channel reception will vary from location to location based on terrain (including trees, buildings, hills
and mountains). The fewer obstructions, the better your chance of receiving strong digital signals. Go
to http://www.digitaluk.co.uk/. Enter your address for a listing of likely channels available in
your area.
Do I need to use an External Amplier?
An amplier can enhance signals weakened by obstructions between you and the broadcast towers.
If yourTV picture is not crystal clear, or you are unable get strong signals from distant towers, you can
use the amplier to boost the weakened signals.
Note: We do NOT recommend using the amplier if your house is very close to the broadcast tower
and the signal is already very strong. A booster will cause self-oscillation and you may actually end up
getting fewer signals than without it.
Will all the channels I receive be High Denition (HD)?
Not all digital signals are High Denition (HD). Make sure you are using a High Denition Television
(HDTV) with built in DVB-T tuner.When connecting the aerial to a third-party receiver, make sure it is
capable of receiving HD. Otherwise no HD channels can be picked up.
里面
Connect the 1.35-meter coaxial cable to the ANT/IN or CABLE IN port on the back
of your TV. Note: For TV’s that require a tuner box, connect the coaxial cable to the
tuner box's ANT/IN or CABLE IN port.
See the “Final Conguration”Illustrations Below for
Both Connection Options
Back of TV
From 1.35-meter
Coaxial Cable
1. Connect the Aerial on the Back of Your TV
ANT/IN
CABLE IN
ANT/IN
Digital
Aerial HDTV
Digital Converter Box
Digital
Aerial
Traditional TV
AC/DC adapter
12V 50mA
AC/DC adapter
12V 50mA
Connected to HDTV with digital tuner inbuilt
Connected to TV through set top box
Two powered choices ① or ②
①Powered by DTV set-top box via coaxial cable (aached)
②Powered via separate AC/DC adapter (packageincluded)
1
2