3S Vision N1011 Instruction manual

RMIM-01G05031 Ver:20
Box Network Camera
ConnecƟon Diagram
Auto-IRIS (Optional)
* This product is applicable for the following models :
Model A: DC12V
Model C: DC12V/AC24V
Model B: DC12V/PoE
Model D: DC12V/Wireless
TV Out (Optional)
* No SD/SDHC Card Slot & Local Storage Function apply for Argentina.

Power

MIC

HUB

Micro SD Card

Speaker

High dB alarm
Alarm output
Alarm input

Alarm

Wireless
Antenna

Reset
Button
TV Out (Optional)
5 seconds
Network Camera
For more information, please refer to the attached CD.

Infrared Inductor
To use this product outdoors, it must be installed in an approved outdoor housing.

8 7 6 5 4 3 2 1 PIN
BOX Network Camera
Making ConnecƟons
Before connect this product, please make sure your PC has the LAN port available for connect to the network.
1
Remove the cover of sensor and connect the lens by
screwing it into the camera clockwise.
NOTE:
1. Adjusting lens mount
Please use a C-CS adapter if your
lens is using C Mount.
2. Lens adjustment
Use the hexagonal wrench to release
the lens ring and adjust the lens,
if there is any unfitted condition
occurred
after the lens is connected.
* Lock the lens after lens connected by keeping screwing.
It will be idle running if the lens is locked.
Connect lens as shown
2
Making Connections
•PC
•HUB
•MIC
•Wireless Antenna
•Speaker
•IRIS Jack
•S
pe
ak
•
•Monitor
•Power
2. MIC In
1. Audio Out
3. Wireless Antenna 10. IRIS Jack
4. POWER LED Indicator
5. RESET Button
6. LAN/POE Socket
7. DC POWER Inlet
8. BNC Connnector
9. Micro SD Card Slot
11. Extension I/O Terminal Block
DESCRIPTION
1. Audio Out Connect to speaker out.
2. MIC In Connect to microphone in.
3. Wireless Antenna Connection to wireless antenna here.
4. Power LED Indicator The led indicator will light in red when the power on.
5. Reset Button Reset to factory setting.
6. LAN/POE Socket Connect to 10/100 RJ45 network / PoE here.
7. DC Power Inlet Connect to power here.
8. BNC Connector Connect the monitor to the BNC adapter.
9. Micro SD Card Slot Insert the micro SD card here.
10. IRIS Jack Connect the lens cable plug to the IRIS Jack.
11. Extension I/O Terminal Block TTL alarm and RS485 connection.
The product can operate on DC12V, DC12V/PoE
based on the model you have.The power inlet of the
Network Camera is non-polarized, it can automatically
determine the type of the incoming current.
2
Extension I/O Terminal Block
* Function of Wireless Antenna, TV Out and Auto IRIS are
available only for the models which are supported.
In addition to the motion detection executed by the
internal software application, ths product provides an
extension I/O terminal block which is used to connect
external infrared detectors, beepers and
smoke detectors.
Alarm output
●High dB alarm
9
●Alarm
●Infrared Inductor
Alarm input
Pin Function Pin Function
1. Alarm In_A 2. Alarm In_K
3. Alarm Out_COM 4. Alarm Out_NC
5. Alarm Out_NO 6. RS485+
7. RS485- 8. DC12V Out
9. GND
* Some function will be different depending on the model.
RMIM-01G05031 Ver:20