3S Vision N5011 Instruction manual

Speed Dome Network Camera
ConnecƟon Diagram
Connect the product to the switch hub and PC.
Network Camera
For more information, please refer to the attached CD.
External I/O Connector
Micro SD Card Slot
(SDHC up to 32GB)
AC/DC Power Inlet
RESET Button
5 seconds
LAN Socket
Twisted-Pair
(Not supplied) ●Power
● HUB
●PC
1
2
Connect to the power outlet
Connect with your power adaptor directly
using the wisted pair (not supplied) after plug
the supplied 2pin connector into J20 as shown.
Connecting up
Prepare the product, your PC and switch hub
ready for connection.Make sure that your PC
has a LAN port available for connection to the
network cable of the product.
3
Connect the switch hub to your PC
Use a network cable and plug it in the LAN
port of the product.
Plug the other end of the cable in the LAN
port of the hub.
4
Plug the External I/O connector
Plug the supplied external I/O connector into
J17 as shown.
External I/O setting
● IR Infrared receiver
●MIC
●High dB alarm
● Alarm
●Speaker
Pin 12 Alarm A (Alarm in)
Pin 11 Alarm K (Alarm in)
Pin 10 Alarm Out NC
Pin 9 Alarm Out COM
Pin 8 Alarm Out NO
Pin 7 RS485-
Pin 6 RS485+
Pin 5 DC 12V out
Pin 4 GND
Pin 3 GND
Pin 2 Audio out
Pin 1 Audio in
●DC out (12V)
5
Turn on the power
Turn on the power of the PC and hub.
●Power
●PC ●HUB
J20
J17
RMIM-01G05038 Ver:03

12
4
5
Network Camera
RMIM-01G05038 Ver:03
Speed Dome Network Camera
Hardware InstallaƟon
Package Contents
Wall Mount Bracket
Cable Glands Unlock / Lock
Use the screwdriver to lock the camera
securely after remove the EPE.
Start the Installation
Tripod Mounting
Stabilize the Hardware
Housings Installation
3
For more information, please refer to the attached CD.
2.Lock
EPE
Use the screwdriver to lock the bracket and Pedestal
securely after the I/O cables are put into the bracket.
ng
1.Unlock
1
2
3
4