4Ddoors GA103 Troubleshooting guide

• Suitable for garages with up to 2 spaces
• Pulling force 600 N
• Door sizes up to 12m2
• Opening speed max. 135 mm/sec.
• Plus optional battery back up
The GA103 garage door operator is loaded with technical innovations.
The second opening height is a standard programmable feature, and the
opening power is 600 N. Owners can also expect the highest level of security
and user safety, along with a 2 Year warranty.
All units are TUV tested and exceed or surpass the most stringent industry
requirements for reliability and performance.
HOW TO PROGRAM
A REMOTE
GA
103
Press and hold button 1
Press the button on the remote
you want to program
Let go (release) both buttons
1
1
2
2
T
THOW TO SET LIMITS AND FORCE
A. Make sure the door is connected to the motor
B. Turn the power off to the motor
C. Press and hold the T button
D. Turn power supply back on while still pressing the T button
E. Keep holding T button 5 seconds minimum
F. Release T button
G. Press T button momentarily and release
H. Door will perform 4 - 5 test operations automatically
I. Door now should work correctly

• Suitable for garages with up to 8 spaces
• Pulling force 750 N
• Door sizes up to 15m2
• Opening speed max. 220 mm/sec.
• 0.5 W in standby mode
• Suitable for garages with up to 30 spaces
• Pulling force 1000 N
• Door sizes up to 20m2
• Opening speed max. 220 mm/sec.
• 0.5 W in standby mode
GA
203
GA
403
Press and hold button 1
Press the button on the remote
you want to program
Let go (release) both buttons
HOW TO PROGRAM
A REMOTE
1
1
2
2
3
3
A. Make sure the door is connected to the motor
B. Press and hold the black button for 10 seconds until you see an L on the display then release it
C. Put the door in the open position using the white button (door open) and the red button (door close)
D. Confirm open position by pressing the black button once
E. Door will perform 4 - 5 test operations automatically
F. Door now should work correctly
HOW TO SET LIMITS AND FORCE

FOR HOME AND INDUSTRY
Coding Instructions
v3 (2 PIN receiver)
GA
203
GA
403
TO CODE NEW REMOTES YOU NEED
TO DO THE FOLLOWING:
Push the RED button on the circuit board and hold
for 10 seconds, a count down will start from 8 to 0,
dE will appear on display when it finishes, please
release the button.
Push the RED button on the circuit board once.
Open motor cover (lid).
Please test your remote
1
0
2
1
The little display will light up with a lower caps r
and 1.
2
Hold down the button on the remote until LED
lights on motor start going brighter.
3
3
Then release the button of the remote.
4
4
Your remote should be coded, press button
to test.
5
2
1
A. Make sure the door is connected to the motor
B. Press and hold the black button for 6 seconds until you see an L on the display then release it
C. Put the door in the open position using the white button (door open) and the red button (door close)
D. Confirm open position by pressing the black button once
E. Door will perform 4 - 5 test operations automatically
F. Door now should work correctly
HOW TO SET LIMITS AND FORCE
DELETE CODING
Way to read board is with your back towards garage door
Art Series
Handset
TA2
TA2