AA Portable Power Corp CH-LF12810A User manual

AA Portable Power Corp.
www.batteryspace.com, Email: [e-mail]
825 S 19th Street, Richmond, CA 94804
Tel: [phone] Fax: [phone]
Page 1 of 3
Specification & Instruction
of
Smart Charger
CH-LF12810A

AA Portable Power Corp.
www.batteryspace.com, Email: [e-mail]
825 S 19th Street, Richmond, CA 94804
Tel: [phone] Fax: [phone]
Page 2 of 3
Specification:
Feature
 Designed for 4S LiFePO4 rechargeable battery with capacity ≥ 10Ah
 For Battery Voltage: 12.8V
 CC-CV Charging mode
 USA AC Plug
 Input Power:
o 100Vac-120Vac, Maximum: 6Amp or
o 220Vac-240Vac, Maximum: 3Amp
 Output Power: 14.6V DC±0.2V, Maximum: 10Amp
Safety Protection
 Output short circuit protection:
o Can reset the charger by unplug AC power cable.
 Over temperature protection:
o When cooling down, the charger will auto recover.
 Low voltage protection:
o If battery’s voltage is <8.76V, the charger will not charge the
battery
 Over voltage protection:
o If the output voltage is >14.6V±0.2V, the charger will stop
working

Wrong
polarity protection
LED
 Solid Green: Connect to AC outlet, without connect to battery
 Solid Red: Charging
 Solid Green: Fully charged/trickle charge
Temperature  Working Temperature: -20°C to 45°C
 Storage Temperature: -20°C to 85°C
Dimension LxWxH: 6.1x3.5x2 inch (155x90x51mm)
Weight 2LB 3oz

AA Portable Power Corp.
www.batteryspace.com, Email: [e-mail]
825 S 19th Street, Richmond, CA 94804
Tel: [phone] Fax: [phone]
Page 3 of 3
Instruction:
Please carefully read the following instruction before you start to use this charger.
Caution:
 This charger is for indoor use only. Do not store the charger outdoors.
 Do not set the output cable, power cord and the charger on a wet surface.
 Do not use the charger with defective power cord and damaged wires.
 The charger shall be placed on a fixed horizontal surface when the charger is
operated.
 Avoid storing or operating the charger in highly humid place or any place
with inflammable good.
 Do not cover the charger when the charger is operated.
 Do not charge the battery on the list below
Designed Voltage < 21.6V
Designed Capacity < 10Ah
 Do not disassembly the charger any time
 AA Portable Power is not responsible for any damage caused by any
misusage
Operation Steps:
1. Charge: Connect AC outlet first, then connect to the battery.
2. Charge finished: Unplug the charge from AC outlet first, then disconnect the
battery.