AA Portable Power Corp PR-CU-R218 User manual


AA Portable Power Corp
www.batteryspace.com, Email: [e-mail]

AAPortablePowerCorp.www.batteryspace.com AAPortablePowerCorp. www.batteryspace.com
PR-CU-R218 Smart Charger
(6.0A) for 14.8 Li-ion/Polymer
Rechargeable Battery Pack
User Manual
Warning
1. Please read the following instruction carefully before use.
2. Improper using the charger will cause the damage of
batteries or possible explosions.


AA Portable Power Corp
www.batteryspace.com, Email: [e-mail]

AAPortablePowerCorp.www.batteryspace.com AAPortablePowerCorp. www.batteryspace.com
1) Product description:
a) CH-L1486is a CE listed intelligent charger designed for 14.8V (4 cells) polymer or
cylindrical Li-Ion battery packs with capacity ≥6000mAh only.
b) Terminal Options:
i) Anderson Connector
2) Features:
a) Worldwide input AC power from AC100-240V, 50-60Hz, USA AC plugs.
b) Over Voltage Protection: The output current is limited when an overload (16.8V/6A) is
detected.
c) Output Reverse Protection: The charger will be cut off when the battery polarity is
wrongly placed.
d) Short Circuit Protection: The charger will be cut off automatically when a short circuit
is detected.
e) LED indicates the charging status.
f) Built in IC to cut off power automatically when the battery is fully charged.
g) The charger comes with one year warranty.
3) Operations:
i) Make sure the battery is properly connected on both positive and negative poles
as shown in Figure 1.
ii) LED indicators will be green when connecting AC power plug only, LED will be
red when a battery is connected to the DC plug and charging. LED will switch to
green automatically when the charging is finished (it takes 2-9 hours to finish
charging a battery, depends on the battery capacity). Disconnect AC plug and
DC plug to stop charging.
4) Technical Specification:
Rated AC Input: AC100-240V 50-60 Hz
Maximum input power: 120W
Rating Output power: 16.8V, 6 A
Efficiency; >90%
Operation Temperature: -10℃-+40℃
Operation Humidity: < 90%
Suit Battery: 14.8V 6-30Ah Li-ion/polymer battery
5) Notice:
a) Use with proper type Li-Ion/polymer battery pack only. Please make sure the battery
voltage matches what labels on the charger (14.8V). The battery will be damaged or it
will not charge if they do not match.
b) The charger must be connected to AC power first before it starts charging (A red LED
must be indicated before connecting the battery to be charged).
c) The battery to be charged must be connected to the charger within 3 minutes after
charger’s on, otherwise the battery will be discharged.
d) Never charge other types of batteries besides polymer and cylindrical Li-Ion.
e) Always place the charger in a well-ventilated, dry environment.
f) Indoor used only, never expose the charger to water such as rain and splash.
g) Never place the charger near radiator, heat register or similar heat source when in
charging.
h) Do not use this charger if any of the following happens:
i) If the power cord or plug is damaged or frayed
ii) If liquid has been spilled into the charger
iii) If the case of the charger is dropped and damaged
iv) If the charger does not behave properly as stated in 3) Operations.