AbbVie Hip Pack User manual

INSTRUCTIONS FOR USE
AbbVie Hip Pack
For use with CADD-Legacy®1400 pump
This guide pertains only to the use of the AbbVie Hip Pack. For questions
or problems, refer to these Instructions for Use or call support toll free at 1-
844-386-4968.

About your Hip Pack:
The Hip Pack is designed to carry a CADD-Legacy®1400 pump This Hip
Pack is intended for single-patient use only. The Hip Pack is intended to
be worn around the waist (see Figure i).
Caring for your AbbVie Hip Pack:
Care: Do not machine wash.
Figure i

Precautions:
CAUTION:When putting on the Hip Pack, ensure the pump is resting on
a flat surface, and will not fall (see Figure ii). If the pump is not
completely secure, it may fall and injure you or damage the pump.
CAUTION:In the event the pump is dropped and no noticeable injury is
suffered, inspect the pump for damage. In the event of pump damage
contact your healthcare provider.
Figure ii

To begin using your Hip Pack:
1) Put on the Hip Pack:
CAUTION:Make sure that the pump is stable on a flat surface, and will
not fall while you put on the Hip Pack.
a. Place the Hip Pack on the front of your waist with the Pull Tab on the
Pump Pocket facing out and the zipper on top.
b. Fasten the clip (see Figure A). Listen for a snap sound.
c. Confirm that the clip is securely fastened.
d. Confirm that the Hip Pack remains on your waist without being held.
Figure A

2) Adjust the Hip Pack:
a. Move the plastic slider along the Waist Strap until the Waist Strap is at
the desired length (see Figure B).
b. Confirm that the pack is held securely against your body. The Hip Pack
should fit comfortably but not move or shift.
3) Insert the pump into the Pump Pocket:
a. Place the pump into the Pump Pocket horizontally with the screen on
your left side and facing out (see Figure C).
b. Using the Pull Tab, confirm that both the display and the keypad are
visible through the Clear Plastic Window.
c. Route the tubing to exit through the Gray Zipper Opening on the top of
the Pump Pocket. Make sure that the tubing is not kinked.
d. Zip the Pump Pocket shut.
Figure B
Figure C

4) Interact with the pump (when needed):
a. You can access the pump’s keypad through the Clear Plastic Window.
b. Use the Pull Tab to view or cover the Clear Plastic Window (see Figure
D).
Figure D

To take off your Hip Pack:
1) Remove the pump from the Pump Pocket:
CAUTION: Make sure that the pump is stable on a flat surface, and will
not fall while you take off the Hip Pack.
a. Pull the zippers to open the Pump Pocket.
b. Remove the pump from the Pump Pocket.
c. Place the pump on a flat surface.
2) Take off the Hip Pack:
a. Undo the clip.
b. Remove the Hip Pack from your waist.

Explanation of Symbols:
Catalog number
Batch code
Manufacturer
Consult Instructions for Use
Caution
10637-04-01
Manufactured for:
AbbVie Inc.
1 North Waukegan Road
North Chicago, IL 60064 USA
©2015AbbVie Inc. All rights reserved.
03-B202