ABI INTERIORS Aliro Ambulant 14755 User manual

ALIRO AMBUL AN T 140 ° GRAB RAIL
Dis cla imer: P ro d u c ts in th is ma n u a l mu s t by la w b e in s talled b y licen s ed an d reg is tered tra d es p eo p le in a cco rd a n ce w ith th e releva n t stan d a rds . A B I a n d th e ma n u fa ctu rer/d is trib u to r
res erve t h e rig h t to va ry s p ecif ic a tio n s o r d elete mo d els fro m t h eir ra n g e w ith o u t prio r n o tif ic a t io n . Dimen s io n s a re n o min a l mea s u remen ts o n ly. Th e in f o rmatio n lis ted is co rrect at th e time
o f p u b lica tio n , h o w ever A B I a n d th e man u f a c tu rer/d is trib u to r ta kes n o res p o n s ib ility fo r p rin tin g erro rs. C o p yrig h t © A B I I n terio rs 2 02 2 Pty Ltd
SPECIFICATIONS
RECOMMENDED USE Domestic/Commercial
MATERIAL 316 Stainless Steel
MOUNTING HARDWARE INCLUDED Yes, M10 x 75mm Coach Screw
STANDARDS AS1 428.1:2021

1
1
9
3
9
IN THE BOX
1
3
End Bracket x 2
140oBracket x 1
90o Ambulant Grab Rail Kit
(numbered components)
Fixing Kit
(unnumbered components)
Coach Screw x 3
O Ring x 3
Fixing Bracket x 3
Washer x 3
Grub Screw x 7
225mm Rail x 2
9

INSTA LLATION G UIDE
3Mark out fixing points centre to centre, on a level floor, ensuring
grab rail placement meets AS1428.1:2021 standards.
Grab rail is compatible in both orientations (same install applies).
4Align fixing points with rail configuration, using a level, double
check fixing location. Drill pilot holes accordingly.
5Secure fixing brackets at previously marked fixing location.
Ensure fixing is level & fixed into appropriate structural support. 6Slide grab rails onto brackets & fix with grub screw. Ensure all fixings are tight and secure.
2
1For rough in, refer to Step 3 for wall structure set out.
Set out grab rail in numbered configuration as illustrated below.
(Numbered indication appears on previous page).
404
292
Quick Tip: If sliding the grab rail onto
the brackets is challenging, it may help
to remove this grub screw during
installation to allow more movement.
Be sure to reinstall the grub screw!
Note: This product must be installed by a licensed tradesperson.
This product’s install must comply with AS1428.1 for installation within
Australia. This is a general installation guide - there are many factors
that are involved that can alter the installation method. ABI takes no
responsibility if your product is not fixed to adequate wall structure.
300
Structure
Structure
Fix grab rails to brackets using allen key provided.
Note: do not tighten grub screws completely, this aids wall
mount install process.
level
419
43
Drill
Coach Screw
Washer
Fixing Bracket
O ring
Pilot hole
DO NOT use crea m
cleaners or bleach.
These substances are
abrasive .
Regularly clean with
mildliquid deterg ent
or soapand water.
DO NOT use cleaning
pads with abrasive
surfaces as this may
scratch the materia l .
1
1
9
3
9IMPORTANT
Loosen grub screws to
aid installation.
Tighten once installed.
IMPORTANT
Place assembled grab rail
against wall to aid
wall marking/check
before drilling.