*Specifications are subject to changes without notice.
User Operation Guide
PRODUCT FEATURES
FRONT/REAR PANEL (DIPP04/AP3)DESCRIPTION
The DiPP04/AP3 is a pair of automatic switcher that switches and scales input from
multiple formats to output onto a display via HDBaseT.
It is able to automatically detect and switch input signals from HDMI, Display Port and
VGA based on manual selection or last connected input. The signal will be automatically
scaled and passed through a single CAT-5 cable using HDBaseT technology to the
display (or receiver) up to 100m.
Bi-directional IR and RS-232 commands can also be passed through the same cable
to control the source and display. Power over cable is also supported, allowing the
receiver or transmitter to power up without connecting to a power adaptor.
The DiPP04/AP3 also comes with a 8 pin 2.54mm connector for convenient integration
with ABtUS IFP-600 series of modular interface panels.
●Automatic input detection &s election
(Based on manual selection or last connected input)
●Supports up to 4K 2K resolutions
●Scaled video output to 1080p @ 60Hz
●Extends HDMI / VGA up to 100m
●Supports bi-directional IR and RS-232
●Support POC (power over cable)
Item Description
1 HDMI IN HDMI input
2 DP IN Display Port input
3 VGA + Audio IN VGA + 3.5mm audio input
4 INPUT STATUS LEDs, litted LED indicates active input.
5 SEL BUTTON Manual source selection button
6 AUTO BUTTON Auto sync for VGA
7 IR IN IR passthrough to receiver
8 IR OUT IR passthrough from receiver
9 RS-232 RS-232 passthrough to receiver
10 DC 24V Power 24V DC
11 UTP/STP OUT CAT-5 output to receiver of HDBaseT compatible displays
(HDBaseT)
Front View Back View
4 5 6 11
1 2 3 7 8 9 10
(Note: The DiPP04/AP3 can be used with HDBT-GAHD11R/AP1)
